Free Qlik QREP Exam Dumps

For tasks involving Kafka as a target in Qlik Replicate, the valid options are:

A . Full Load and Apply Change: This combination is valid because Kafka can be used both for initial full loads of data and for applying changes captured through CDC (Change Data Capture). In a task with a Kafka target endpoint, each source record is transformed into a message which is then written to a partition in the specified topic1.

The other options are not typically used with Kafka in Qlik Replicate:

B . Full Load and Stage Change: Staging changes is not a standard task option when using Kafka as a target.

C . Apply Change and Store Change: While Kafka can be used to apply changes, the ''Store Change'' option is not a recognized task option for Kafka targets.

D . Full Load and Store Change: Similarly, ''Store Change'' is not a standard task option for Kafka targets.

For more information on how to set up and use Kafka as a target endpoint in Qlik Replicate, including the configuration of Full Load and Apply Change tasks, you can refer to the official Qlik community articles and support resources21.

Questions no: 21 Verified Answer: = C. As close as possible to the source system

Step by Step Comprehensive and Detailed Explanation with all Reference: = In an on-premises environment, Qlik Replicate should be set up as close as possible to the source system. This is because the source system is where the initial capture of data changes occurs, and having Qlik Replicate close to the source helps to minimize latency and maximize the efficiency of data capture.

C . As close as possible to the source system: Positioning Qlik Replicate near the source system reduces the time it takes to capture and process changes, which is critical for maintaining low latency in replication tasks1.

The other options are not recommended because:

A . As close as possible to the target system: While proximity to the target system can be beneficial for the apply phase, it is more crucial to have minimal latency during the capture phase, which is closer to the source.

B . In the ''middle'' between the source and target: This does not provide the optimal configuration for either the capture or apply phases and could introduce unnecessary complexity and potential latency.

D . In a cloud environment: This option is not relevant to the question as it specifies an on-premises setup. Additionally, whether to use a cloud environment depends on the specific architecture and requirements of the replication scenario.

For detailed guidance on setting up Qlik Replicate in an on-premises environment, including considerations for placement and configuration to optimize performance and reduce latency, you can refer to the official Qlik Replicate Setup and User Guide1.