Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

NetApp NS0-184 Exam - Topic 3 Question 83 Discussion

After the installation of a new ONTAP 9.8 cluster, you have to verify if AutoSupport works.In this scenario, which two commands would you use to accomplish this task? (Choose two.)
A) system node autosupport history show and B) system node autosupport check show
C) system node autosupport destination show
D) system node autosupport invoke

NetApp NS0-184 Exam - Topic 3 Question 83 Discussion

Actual exam question for NetApp's NS0-184 exam
Question #: 83
Topic #: 3
[All NS0-184 Questions]

After the installation of a new ONTAP 9.8 cluster, you have to verify if AutoSupport works.

In this scenario, which two commands would you use to accomplish this task? (Choose two.)

Show Suggested Answer Hide Answer
Suggested Answer: A, B

by Leota at May 06, 2026, 02:00 PM

Limited Time Offer

25%

Off

Get Premium NS0-184 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Iesha
1 month ago
I feel like option D might be relevant too, but I can't recall if it's for checking or actually sending a test message.
upvoted 0 times
...
Simona
1 month ago
I remember practicing with these commands, and I think option C could be useful to verify the destinations for AutoSupport.
upvoted 0 times
...
Ryan
1 month ago
I think we need to check the AutoSupport history to see if any messages were sent, so maybe option A? But I'm not sure about the second command.
upvoted 0 times
...

Save Cancel