Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25

- Free Preparation Discussions

Huawei Exam H12-831_V1.0 Topic 6 Question 68 Discussion

Actual exam question for Huawei's H12-831_V1.0 exam

Question #: 68
Topic #: 6

[All H12-831_V1.0 Questions]

On the OSPFv3 network shown in the figure, OSPFv3 is enabled on the interfaces connecting R1, R2, and R3. The router ID of each router is 10.0.X.X, where X is the number of the router. If you check detailed information about an LSA on R3, the command output shows that the LSA is generated by R2 and describes the IPv6 prefix address associated with the Router-LSA.

ATRUE

BFALSE

Show Suggested Answer

Suggested Answer: A

by Julianna at Apr 08, 2025, 05:23 AM

Limited Time Offer

25%

Off

Get Premium H12-831_V1.0 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Helga

1 months ago

Okay, let me think this through. If the LSA describes the IPv6 prefix of R3, then the answer must be TRUE, right? Or is there some trick here...

upvoted 0 times

Dorothy

That makes sense. So, the LSA is not generated by R3 itself, but by R2, describing the IPv6 prefix of R3. The answer should indeed be TRUE.

upvoted 0 times

...

Skye

15 days ago

Yes, you are correct. The LSA is generated by R2 and describes the IPv6 prefix address associated with the Router-LSA, so the answer is TRUE.

upvoted 0 times

...

Nickolas

18 days ago

Yes, you are correct. The LSA describing the IPv6 prefix of R3 means it was generated by R2, so the answer is TRUE.

upvoted 0 times

...

...

Eleonore

1 months ago

I also believe the answer is A) TRUE, as the LSA describes the IPv6 prefix address associated with the Router-LSA.

upvoted 0 times

...

Elsa

1 months ago

I agree with Dominga, because the LSA is generated by R2.

upvoted 0 times

...

Dominga

1 months ago

I think the answer is A) TRUE.

upvoted 0 times

...

Colene

1 months ago

Haha, this question is giving me a headache. I bet the answer is 'It Depends' - it always is with these OSPF questions!

upvoted 0 times

Glen

19 days ago

A) TRUE

upvoted 0 times

...

...

Rickie

1 months ago

Hold on, I thought the router ID was supposed to be unique for each router. How can R1, R2, and R3 all have the same router ID format of 10.0.X.X?

upvoted 0 times

...

Gennie

2 months ago

Wait, so the LSA is generated by R2 but describes the IPv6 prefix of R3? That's a bit confusing, don't you think?

upvoted 0 times

Benton

23 days ago

I agree, it's strange that the LSA is generated by R2 but describes the IPv6 prefix of R3.

upvoted 0 times

...

Dulce

24 days ago

Yes, it does seem confusing. Maybe there was a mistake in the configuration.

upvoted 0 times

...

...