Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

HPE6-A85 Exam - Topic 1 Question 54 Discussion

Actual exam question for HP's HPE6-A85 exam
Question #: 54
Topic #: 1
[All HPE6-A85 Questions]

Which commands are used to set a default route to 10.4.5.1 on an Aruba CX switch when ln-band management using an SVl is being used?

Show Suggested Answer Hide Answer
Suggested Answer: C

The command that is used to set a default route to 10.4.5.1 on an Aruba CX switch when in-band management using an SVI is being used is ip route 0.0 0 0/0 10.4.5.1 . This command specifies the destination network address (0.0 0 0) and prefix length (/0) and the next-hop address (10.4.5.1) for reaching any network that is not directly connected to the switch. The default route applies to the default VRF Virtual Routing and Forwarding. VRF is a technology that allows multiple instances of a routing table to co-exist within the same router at the same time. VRFs are typically used to segment network traffic for security, privacy, or administrative purposes. , which is used for in-band management traffic that goes through an SVI Switch Virtual Interface. SVI is a virtual interface on a switch that allows the switch to route packets between different VLANs on the same switch or different switches that are connected by a trunk link.An SVI is associated with a VLAN and has an IP address and subnet mask assigned to it12. Reference:1https://www.arubanetworks.com/techdocs/AOS-CX/10_08/HTML/ip_route_4100i-6000-6100-6200/Content/Chp_StatRoute/def-rou.htm2https://www.arubanetworks.com/techdocs/AOS-CX/10_08/HTML/ip_route_4100i-6000-6100-6200/Content/Chp_VRF/vrf-overview.htm


by Lamonica at Apr 04, 2026, 10:44 PM

Limited Time Offer

25%

Off

Get Premium HPE6-A85 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Buddy
6 days ago
I’m leaning towards option B, but I’m confused about the VRF part. We didn’t cover that in detail.
upvoted 0 times
...
Eugene
11 days ago
I feel like "ip default-gateway" is more for layer 2 switches, but I can't recall if it applies here.
upvoted 0 times
...
Valentine
16 days ago
I remember there was a question about default routes in our last practice exam, and I think "ip route 0.0.0.0 0.0.0.0 10.4.5.1" was the right format.
upvoted 0 times
...
Amie
21 days ago
I think the command for setting a default route is similar to what we practiced, but I'm not sure if it's "ip route" or "default-gateway."
upvoted 0 times
...

Save Cancel