Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 300-610 Exam - Topic 3 Question 76 Discussion

Refer to the exhibit In this scenario a Cisco engineer is building a loop-free topology where a dedicated layer of the vPC domain adjacent to the aggregation layer which also runs vPC Is used to interconnect the two data centers together. The engineer globally configures a vPC domain identifier on both vPC devices where the domain ID is the same on both peer devices. Which action successfully forms the domain?
A) Configure vPC-peer-keepalive link on both peer devices
B) Put peer device interfaces into a suspended state.
C) Enable and reuse an ISL Layer 3 trunk port channel
D) Synchronize the MAC addresses for the member ports

Cisco 300-610 Exam - Topic 3 Question 76 Discussion

Actual exam question for Cisco's 300-610 exam
Question #: 76
Topic #: 3
[All 300-610 Questions]

Refer to the exhibit In this scenario a Cisco engineer is building a loop-free topology where a dedicated layer of the vPC domain adjacent to the aggregation layer which also runs vPC Is used to interconnect the two data centers together. The engineer globally configures a vPC domain identifier on both vPC devices where the domain ID is the same on both peer devices. Which action successfully forms the domain?

Show Suggested Answer Hide Answer
Suggested Answer: A

by Jolene at Oct 19, 2023, 07:35 PM

Limited Time Offer

25%

Off

Get Premium 300-610 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Merissa
9 months ago
Wait, can you really reuse an ISL Layer 3 trunk? That seems risky!
upvoted 0 times
...
Maurine
10 months ago
D is not necessary if the domain ID is the same.
upvoted 0 times
...
Helaine
10 months ago
C sounds interesting, but I doubt it would work for this scenario.
upvoted 0 times
...
Timothy
10 months ago
I think B is a bad idea; suspending interfaces won't help.
upvoted 0 times
...
Nickolas
10 months ago
A is definitely the right choice for forming the vPC domain.
upvoted 0 times
...
Dorcas
10 months ago
Synchronizing MAC addresses sounds familiar, but I don't recall it being a necessary step for forming the vPC domain.
upvoted 0 times
...
Willard
11 months ago
I practiced a similar question where we had to configure vPC settings, and I think enabling the peer-keepalive link was key in that scenario too.
upvoted 0 times
...
Jacquelyne
11 months ago
I'm not entirely sure, but I feel like putting interfaces into a suspended state might not help with forming the domain.
upvoted 0 times
...
Domonique
11 months ago
I remember something about the vPC peer-keepalive link being crucial for forming the domain. I think that's the right answer.
upvoted 0 times
...
Charlene
11 months ago
Based on my understanding, configuring the vPC-peer-keepalive link on both peer devices is the correct action to take to form the vPC domain.
upvoted 0 times
...
Shayne
11 months ago
Okay, the question is asking about the specific actions needed to successfully form the vPC domain, so I'll need to analyze each option closely.
upvoted 0 times
...
Helene
11 months ago
This question seems straightforward, I think the key is to focus on the requirements for forming the vPC domain.
upvoted 0 times
...
Sarah
11 months ago
I'm a bit confused by the details here, I'll need to carefully review the options and think through the steps to set up the vPC domain.
upvoted 0 times
...
Jackie
11 months ago
Hmm, this seems like a tricky one. I'll need to carefully consider the factors that can impact the end date of the release.
upvoted 0 times
...
Tess
11 months ago
My strategy is to look for the option that shows Content Fragments linked to multiple channels. That looks like the most scalable approach for reusing content.
upvoted 0 times
...
Jutta
11 months ago
I think I've got it! Attr and Element nodes can hold values, but Comment and Document nodes don't. I'll go with those two.
upvoted 0 times
...
Kiley
11 months ago
I'm a bit confused on the difference between reinforcing and punishing consequences. I'll need to review my notes to make sure I have that distinction clear before answering this.
upvoted 0 times
...
Twanna
11 months ago
I remember practice questions mentioning HTTPS connections for secure traffic, so that could be one of the answers.
upvoted 0 times
...
Truman
2 years ago
Well, option C talks about enabling and reusing an ISL Layer 3 trunk port channel. That doesn't really fit the scenario, which is about a vPC domain, not a Layer 3 trunk.
upvoted 0 times
...
Fletcher
2 years ago
Exactly, that's more of a secondary configuration, not the key action required to successfully form the vPC domain.
upvoted 0 times
...
Azzie
2 years ago
And option D, synchronizing the MAC addresses for the member ports? That might be important, but it's not the primary step for forming the vPC domain, is it?
upvoted 0 times
...
Tayna
2 years ago
Right, the question specifically mentions a vPC domain, so anything involving Layer 3 is probably not the right answer.
upvoted 0 times
...

Save Cancel