Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Cisco 300-420 Exam - Topic 2 Question 60 Discussion

Actual exam question for Cisco's 300-420 exam
Question #: 60
Topic #: 2
[All 300-420 Questions]

An engineer must use YANG with an XML representation to configure a Cisco IOS XE switch with these specifications:

IP address 10.10.10.10/27 configured on the interface GigabitEthernet2/1/0

connectivity from a directly connected host 10.10.10.1/27

Which YANG data model set must the engineer choose?

A)

B)

C)

D)

Show Suggested Answer Hide Answer
Suggested Answer: D

Contribute your Thoughts:

0/2000 characters
Penney
5 months ago
Surprised this is even a question, thought it was common knowledge!
upvoted 0 times
...
Danica
5 months ago
I’m not sure about that, C seems too specific.
upvoted 0 times
...
Bernardo
5 months ago
Wait, why is everyone ignoring Option A?
upvoted 0 times
...
Mose
5 months ago
Definitely going with Option B!
upvoted 0 times
...
Marylin
5 months ago
I think Option C is the right choice for this.
upvoted 0 times
...
Therese
5 months ago
I thought option A was for routing protocols, so I'm leaning towards D, but I'm still a bit confused.
upvoted 0 times
...
Kristeen
5 months ago
I feel like option C might be the right choice, but I can't quite recall the details of the model.
upvoted 0 times
...
Louis
6 months ago
I think we practiced a similar question about configuring IP addresses on interfaces. Was it option B that we used?
upvoted 0 times
...
Hannah
6 months ago
I remember studying the YANG models, but I'm not sure which one specifically applies to interface configurations.
upvoted 0 times
...
Heidy
6 months ago
Okay, I've got this. Higher interest rates mean the company's borrowing costs will go up, so that's going to squeeze their margins. Consumers may also pull back on spending, so sales could take a hit. I'll select the answer that captures those effects.
upvoted 0 times
...
Ressie
6 months ago
I've got a good feeling about this one. Based on my understanding of the Audit Logs, I think the answer is Logon Accounts, since that's typically a core part of the audit log data.
upvoted 0 times
...
Margot
6 months ago
Hmm, I'm a bit confused on this one. I know the ping command is used to test network connectivity, but I'm not sure about the specific circumstances that would trigger the "(DUP!)" output. I'll need to think this through carefully.
upvoted 0 times
...
Tula
6 months ago
I'll read through the options slowly and try to eliminate the ones that don't fit.
upvoted 0 times
...

Save Cancel