Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

NetApp Exam NS0-593 Topic 1 Question 43 Discussion

Actual exam question for NetApp's NS0-593 exam
Question #: 43
Topic #: 1
[All NS0-593 Questions]

A customer wants to connect a NetApp AFF A700 system to a 40GbE switch. The controllers have a 10/40G Ethernet card in slot 4 for this purpose. The link comes up fine on node 2, but it will not come up on node 1. You look at the AutoSupport data for the nodes in question and see the output shown in the exhibit.

What is the cause of the customer's problem?

Show Suggested Answer Hide Answer
Suggested Answer: D

= The cause of the customer's problem is that the port has an incorrect SFP inserted.According to the AutoSupport data, the node 1 has a device type of XL710 BQ, which is a 40GbE adapter that requires a QSFP+ transceiver1.However, the part number of the adapter is 111-02590, which is a 10GbE adapter that requires a SFP+ transceiver2. This mismatch prevents the link from coming up on node 1.The customer should replace the adapter with the correct one or use a compatible transceiver for the existing adapter.Reference=1:NetApp Hardware Universe - X1144A2:NetApp Hardware Universe - X1147A


by Lettie at Apr 21, 2024, 11:28 PM

Limited Time Offer

25%

Off

Get Premium NS0-593 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Merilyn
11 months ago
Yes, that could also be the cause of the issue.
upvoted 0 times
...
Dottie
11 months ago
Or maybe the SFP inserted is not compatible.
upvoted 0 times
...
Merilyn
11 months ago
That's a good point, it could be the configuration.
upvoted 0 times
...
Gilma
11 months ago
But what if the ports are configured incorrectly?
upvoted 0 times
...
Dottie
11 months ago
I agree with it could be the cable.
upvoted 0 times
...
Merilyn
12 months ago
I think the problem is with the cable.
upvoted 0 times
...
Salome
12 months ago
That should solve the issue.
upvoted 0 times
...
Kimi
1 years ago
Looks like it. Node Tasia needs to be reconfigured for 40Gbit.
upvoted 0 times
...
Tasia
1 years ago
So, the ports on node are configured incorrectly?
upvoted 0 times
...
Salome
1 years ago
Node Tasia shows '4xTasia0Gbit' while node Kimi shows '40Gbit'.
upvoted 0 times
...
Kimi
1 years ago
Let's check the AutoSupport data for both nodes.
upvoted 0 times
...
Tasia
1 years ago
The link is not coming up on node .
upvoted 0 times
...

Save Cancel