Trusted Huawei H35-561 Exam Dumps – Avoid Costly Exam Retakes

Question No: 1

MultipleChoice

Regarding the description of TA, which of the following options is wrong?

Options

AIn the EPS network, the basic unit of location management is the TA list (tracking area List)

BA TA list includes one or more TAs

CThe purpose of using the TA list is to prevent the UE from frequently initiating the tracking area update (TAU) process

DThe TA list is issued to the UE when the bearer is activated

Question No: 2

MultipleChoice

How many codewords can be transmitted at most for a TT in the LTE system?

Options

A1

B2

C3

D4

Question No: 3

MultipleChoice

Both LTE uplink and downlink use SC-FDMA technology.

Options

ATrue

BFalse

Question No: 4

MultipleChoice

Which of the following description about TA List is not ?

Options

Anetwork to the user paging will work in the TA list all TA

Breasonable TA List distribution mode and design method can effectively reduce the probability of TAU, improve resource utilization

CTA List can in the process of attachment, TAU or GUTI reallocation, allocated by the ENODEB to UE

DFor UE registered tracking area, if in the same TA List, by the same MME to provide services to reduce update signaling

Question No: 5

MultipleChoice

Which of the following description about GPS laying principles are ? (Multiple choice)

Options

Awhen 130m <L < 220m, using 7/8 'cable

Bwhen L < 130m, using 1/4 'cable

Cwhen L> 220m, can use 1/2 'feeder + amplifier manner

DAll above are

Question No: 6

MultipleChoice

When CPRI uitzoomen distance is greater than 20km and less than 40km, LBBPd3 maximum support 3x20M 2T2R.

Options

ATrue

BFalse

Question No: 7

MultipleChoice

The size of time slot in FDD-LTE is 0.5ms.

Options

ATrue

BFalse

Question No: 8

MultipleChoice

Which of the following modulation method can LTE system support? (Multiple choice)

Options

AQPSK

B16QAM

C64QAM

DGMSK

Question No: 9

MultipleChoice

As long as the ANR switch is open, even if not configured pilot frequency frequency point, pilot frequency ANR function will take effect.

Options

ATrue

BFalse

Question No: 10

MultipleChoice

In Huawei NodeB, scheduling mode only includes dynamic scheduling and semi-static scheduling.

Options

ATrue

BFalse

Question No: 11

MultipleChoice

Which of the following interface is based on S1-AP protocol?

Options

AS1-MME

BS1-U

CS5/S8

DS6a

Question No: 12

MultipleChoice

In the Uu interface, which of the following layer performs traffic monitoring report function?

Options

ARRC

BPDCP

CBMC

DMAC

ERLC

Question No: 13

MultipleChoice

AS security procedures, MME issued key, view messages, in which of the following messages exist encryption algorithms and security key?

Options

AAuthentication information Answer (HSS sent to MME)

BSecurity Mode Command (MME sent to UE)

CINIT CONTEXT SETUP REQ (MME sent to eNodeB)

DNone of the above

Question No: 14

MultipleChoice

Which of the following reasons will cause radio frequency unit accept channel RTWP/RSSI too low alarm? (Multiple choice)

Options

Aabnormal feeder installation or poor head process

Bantenna feeder port connected feed cable exist extrusion, bend or feed cable damage

Cradio frequency unit master set or diversity reception channel fault

Dradio frequency unit master set or diversity antenna exist alone outside interference data configuration fault

Question No: 15

MultipleChoice

Which of the following is a UPEUc output power and 2 piece of UPEU output power in current mode?

Options

A300w/360w

B300w/600w

C360w/360w

D360w/650w

Question No: 16

MultipleChoice

In SAE, which of the following entity use to deal with the control plane of S1 interface?

Options

AMME

BSGW

CPDN GATEWAY

DPCRF

Question No: 17

MultipleChoice

In LTE, the uplink pilot signal includes DMRS and Sounding RS.

Options

ATrue

BFalse

Question No: 18

MultipleChoice

D, F, E spectrum corresponding frequency band are respectively 38,39, 40; the corresponding frequency range respectively is 2570-2620,1880-1920,2300-2400.

Options

ATrue

BFalse

Question No: 19

MultipleChoice

Assuming other conditions are unchanged, if the power parameter PB is changed from 0 to 1, then which of the following statements is ?

Options

ACell reference signal power is increased by 3d

BCell reference signal power is increased by 1dB

CCell reference signal power is reduced by 3dB

DCell reference signal power is reduced by 1dB

Question No: 20

MultipleChoice

Which of the following information can be observed directly through the Probe drive test tool? (Multiple choice)

Options

APUSCH, PUCCH, RACH, and sRS physical channel transmit power

BTM mode

CNumber of occupied carriers

DUE real-time transmit power

Free Huawei H35-561 Exam Dumps May 2026