Free Huawei H12-351_V1.0 Exam Dumps August 2026

According to the Huawei documents and resources, the HLD phase is the high-level design phase of a WLAN project. It involves the following items:

Capacity planning: Determines the number and types of devices required for the WLAN network based on the customer's requirements and network scale.

Network design: Designs the network topology, IP addressing scheme, VLAN division, security policies, and other network parameters for the WLAN network.

Deployment planning: Plans the deployment sequence, schedule, resources, and risks for the WLAN project.

AP position planning is not involved in the HLD phase. It is part of the LLD phase, which is the low-level design phase of a WLAN project. It involves the detailed design of AP positions, antenna types, channel allocation, power adjustment, and other wireless parameters for the WLAN network. Therefore, C is the correct answer. Reference: https://support.huawei.com/enterprise/en/doc/EDOC1100158948/9a0d5c37/wlan-project-design

WPA3 has the following advantages over WPA and WPA2:

Supports WPA3-SAE, which provides more secure authentication and key management than PSK.

Provides a more secure handshake protocol than 802.11i, which can resist offline dictionary attacks and protect forward secrecy.

Enhances the algorithm strength from AES-128 to AES-192 or AES-256.

Supports Suite A cryptography, which provides higher security levels for government or military networks.

iMaster NCE-CampusInsight comprehensively analyzes WLAN client access, displays success rates and time consumption of association, authentication, and DHCP. It also provides issue analysis and optimization suggestions.

According to the Huawei documents and resources, EAP termination and EAP relay are typical 802.1X authentication modes between the access device and authentication server. In EAP termination mode, the access device terminates EAP packets and encapsulates them into RADIUS packets.In EAP relay mode, the access device directly encapsulates the received EAP packets into RADIUS using EAP over RADIUS (EAPoR) packets2.Therefore, A and B are the correct answers. Reference:2: https://support.huawei.com/enterprise/en/doc/EDOC1100086527

The home agent is a device that communicates with the gateway on the STAs' home network at Layer 3 and maintains the binding entries of STAs' home addresses and care-of addresses. A home WAC can function as a home agent of STAs, while a home AP cannot.

iMaster NCE-CampusInsight provides intelligent radio calibration for high-load APs to increase the frequency bandwidth. However, this function applies only to the 5 GHz frequency band, not to the 2.4 GHz frequency band.

ATP stands for Acceptance Test Plan, which is a document that needs to be output after the low level design is complete. The ATP describes the acceptance criteria and test cases for the project.

An AP may preferentially use the BTM mode to steer some STAs that are compliant with 802.11v protocol. BTM stands for BSS Transition Management, which is a feature defined in 802.11v protocol that allows an AP to send a request to a STA to switch to another BSS.