Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Huawei H12-811_V1.0 Exam - Topic 1 Question 86 Discussion

On the network shown in the following figure, assuming that SWA, SWB, and SWC retain factory defaults, which of the following ports will be selected as a designated port?
B) G0/0/3 on SWA
A) G0/0/2 on SWC
C) G0/0/1 on SWB
D) G0/0/1 on SWC

Huawei H12-811_V1.0 Exam - Topic 1 Question 86 Discussion

Actual exam question for Huawei's H12-811_V1.0 exam
Question #: 86
Topic #: 1
[All H12-811_V1.0 Questions]

On the network shown in the following figure, assuming that SWA, SWB, and SWC retain factory defaults, which of the following ports will be selected as a designated port?

Show Suggested Answer Hide Answer
Suggested Answer: B

by Linette at Jul 29, 2025, 11:30 AM

Limited Time Offer

25%

Off

Get Premium H12-811_V1.0 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Meaghan
9 months ago
Wait, are we sure about that? Seems off to me.
upvoted 0 times
...
Idella
9 months ago
Totally agree, that's the default behavior!
upvoted 0 times
...
Destiny
10 months ago
I think G0/0/1 on SWB could be a contender too.
upvoted 0 times
...
Lauran
10 months ago
G0/0/3 on SWA is definitely not it, factory defaults matter!
upvoted 0 times
...
Carin
10 months ago
G0/0/2 on SWC is usually the designated port.
upvoted 0 times
...
Golda
10 months ago
I can't recall if the factory default settings affect the port selection directly. Should I consider the MAC addresses too?
upvoted 0 times
...
Amos
11 months ago
I feel like I might be mixing up the port numbers. Was G0/0/2 on SWC the one we discussed in class?
upvoted 0 times
...
Glen
11 months ago
I think we practiced a similar question where we had to identify designated ports based on port priorities. I hope that helps!
upvoted 0 times
...
Vallie
11 months ago
I remember that the designated port is usually the one with the lowest bridge ID, but I'm not sure how that applies here.
upvoted 0 times
...
Leonora
11 months ago
I've got this! Since the switches are in their default configuration, the port with the lowest port ID will be selected as the designated port. Time to analyze the port IDs.
upvoted 0 times
...
Gearldine
11 months ago
Whoa, this is a tricky one. I'm a bit confused on how STP selects the designated port in this scenario. I'll need to review my notes.
upvoted 0 times
...
Charlene
12 months ago
Okay, I remember learning about STP in class. Let me try to visualize the network topology and apply the STP rules.
upvoted 0 times
...
Jutta
12 months ago
Hmm, this looks like a Spanning Tree Protocol (STP) question. I'll need to think through the STP port selection process to determine the designated port.
upvoted 0 times
...

Save Cancel