MENU
With Aruba CX 6300. how do you configure ip address 10 10 10 1 for the interface in default state for interface 1/1/1?
Suggested Answer: B
Get Premium HPE7-A01 Questions
as Interactive Web-Based Practice Test or PDF
Real Exam Format
Detailed Explanations
Instant Access
Get Your Practice Test
To configure an IP address for an interface in default state for interface 1/1/1 on Aruba CX 6300 switch, you need to disable switching on the interface first with the commandno switching. Then you can assign an IP address with the commandip address. The other options are incorrect because they either do not disable switching or use invalid keywords such asswitchingorrouting. Reference: https://www.arubanetworks.com/techdocs/AOS-CX_10_08/UG/bk01-ch01.html https://www.arubanetworks.com/techdocs/AOS-CX_10_08/UG/bk01-ch02.html
12 comments · newest first
TI
Tiera
2 months ago
Option B seems wrong. "No switching" doesn't make sense for this setup.
DE
Derick
2 months ago
I prefer option C. It's straightforward and clear.
RO
Roxane
2 months ago
I think option A is the best choice. It includes switching.
DI
Dierdre
3 months ago
Really? I thought you needed to enable routing first!
LA
Lai
3 months ago
I agree with C, it's straightforward and clear.
AL
Alberta
3 months ago
Wait, isn't D missing a dot in the IP?
FE
Felicitas
3 months ago
I think A is better, it specifies switching.
KR
Kristian
3 months ago
Option C is the correct syntax!
CA
Candida
3 months ago
I think option A might be correct since it mentions "switching," but I’m not entirely sure if the IP address format is right. I need to double-check the subnet mask.
LA
Latrice
4 months ago
I’m a bit confused about the "switching" and "routing" terms in the options. I remember there was a distinction in the last practice exam we did, but I can't remember which one applies here.
AL
Aliza
4 months ago
I practiced a similar question where we had to configure an IP address, and I feel like option C looks familiar. But I can't recall if the syntax is exactly right.
JU
Junita
4 months ago
I think the command should start with "int 1/1/1" but I'm not sure about the rest. I remember something about the subnet mask needing to be specified correctly.