Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Fortinet NSE6_SDW_AD-7.6 Exam - Topic 4 Question 4 Discussion

(You configure the overlay tunnels for an SD-WAN hub-and-spoke topology defined with IPsec tunnels, BGP on loopback, and dynamic BGP.Which are two recommended IPsec settings for this topology? Choose two answers.)
A) On the spoke, set the parameter net-device to enable. and B) On the spoke, configure the parameter localid.
C) On the hub, set the parameter mode-cfg to enable.
D) On the hub, set the tunnel type to static.

Fortinet NSE6_SDW_AD-7.6 Exam - Topic 4 Question 4 Discussion

Actual exam question for Fortinet's NSE6_SDW_AD-7.6 exam
Question #: 4
Topic #: 4
[All NSE6_SDW_AD-7.6 Questions]

(You configure the overlay tunnels for an SD-WAN hub-and-spoke topology defined with IPsec tunnels, BGP on loopback, and dynamic BGP.

Which are two recommended IPsec settings for this topology? Choose two answers.)

Show Suggested Answer Hide Answer
Suggested Answer: A, B

by Isaac at Apr 05, 2026, 10:05 PM

Limited Time Offer

25%

Off

Get Premium NSE6_SDW_AD-7.6 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Kenneth
3 hours ago
I think B and C are the best choices. Localid is crucial.
upvoted 0 times
...
Werner
5 days ago
Not sure about C, I thought it was optional.
upvoted 0 times
...
Erin
10 days ago
Totally agree with A and C!
upvoted 0 times
...
Olga
16 days ago
Wait, isn't D a bit outdated for this setup?
upvoted 0 times
...
Micaela
2 months ago
I think B is also important, though.
upvoted 0 times
...
Stephaine
2 months ago
A and C are definitely the way to go.
upvoted 0 times
...
Erasmo
3 months ago
I’m leaning towards option C and D, but I’m not confident about the tunnel type needing to be static on the hub.
upvoted 0 times
...
Ocie
3 months ago
I feel like I read something about net-device being important for spokes, but I can't recall if it was option A or not.
upvoted 0 times
...
Sonia
3 months ago
I remember practicing a similar question where we had to enable certain parameters on the hub. Maybe option C is correct too?
upvoted 0 times
...
Glendora
3 months ago
I think option B about configuring the localid on the spoke sounds familiar, but I'm not entirely sure if it's the best choice.
upvoted 0 times
...

Save Cancel