MENU
The SSD has failed in a Dell EMC PowerScale H400 node that has one SSD installed. A technician is asked to replace it.
Where should the new drive be installed?
In a Dell EMC PowerScale H400 node that has one SSD installed and requires replacement, the new SSD should be installed in the correct slot to ensure proper operation.
Key Points:
SSD Slot Location:
The H400 node uses sleds for drive placement.
SSDs are installed in specific positions to support metadata acceleration and caching functions.
Position 0 and sled E is designated for the SSD in an H400 node.
Drive Replacement Procedure:
Identify the correct sled and position for the SSD.
Power down the node if necessary, following safety procedures.
Remove the faulty SSD and install the new SSD in the correct slot.
Importance of Correct Placement:
Installing the SSD in the wrong slot can lead to the node not recognizing the drive.
May affect the performance and data protection features of the cluster.
Dell PowerScale Reference:
Dell EMC PowerScale Hardware Replacement Guide:
Section on SSD Replacement for H400 Nodes:
Specifies that the SSD should be installed in Position 0 of sled E.
Provides diagrams and step-by-step instructions.
Node Documentation:
Illustrates the drive bay numbering and sled identification.
Emphasizes the importance of installing drives in the correct positions.
Incorrect Options:
Option A (Left slot at the back of the node) and Option D (Right slot at the back of the node) do not correspond to the correct SSD slot.
Option B (Position 0 and sled A) is not the designated slot for the SSD in an H400 node.