Refer to the exhibit.

What is the result of the network configuration shown for a Dell PowerStore T?
1. Run vlt-domain <ID> to create a new VLTi domain.
2. Run discovery-interface ethernet chassis/slot/portchassis/slot/port to add the two VLTi ports to the new domain. 3. Run backup destination <IP address of the other switch> to set the other switch as VLT backup, which is required for VLT heartbeat. #(conf-range-eth1/1/55-1/1/56) vlt-domain 1 #(conf-vlt-1) discovery-interface ethernet 1/1/55-1/1/56 #(conf-vlt-1) backup destination 172.17.57.30
Currently there are no comments in this discussion, be the first to comment!