Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Dell EMC D-PDD-DY-23 Exam - Topic 1 Question 28 Discussion

When the PowerProtect DD system boots up for the first time, the CU configuration wizard script does not start automatically.Which of the following can you do to start the configuration wizard manually? (Choose two.)
A) Use the config setup CLI command and E) In the DD System Manager select Maintenance > System > Configure System
B) Use the configure terminal CLI command
C) Restart the system and the configuration wizard appears after you log in as sysadmin
D) Use the adminaccess configure CLI command

Dell EMC D-PDD-DY-23 Exam - Topic 1 Question 28 Discussion

Actual exam question for Dell EMC's D-PDD-DY-23 exam
Question #: 28
Topic #: 1
[All D-PDD-DY-23 Questions]

When the PowerProtect DD system boots up for the first time, the CU configuration wizard script does not start automatically.

Which of the following can you do to start the configuration wizard manually? (Choose two.)

Show Suggested Answer Hide Answer
Suggested Answer: A, E

Use the config setup CLI command: This command starts the configuration wizard from the command-line interface, allowing you to set up the system manually.

In the DD System Manager select Maintenance > System > Configure System: If you are using the graphical DD System Manager interface, you can navigate to the 'Maintenance' section and select 'Configure System' to launch the configuration wizard.


by Lindsey at May 15, 2026, 11:27 PM

Limited Time Offer

25%

Off

Get Premium D-PDD-DY-23 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Gary
5 days ago
I disagree, B seems like a valid option too.
upvoted 0 times
...
Jose
10 days ago
Definitely surprised the wizard doesn't start automatically.
upvoted 0 times
...
Alease
15 days ago
I thought restarting would work, but it doesn't.
upvoted 0 times
...
Nieves
20 days ago
A and E are the correct options!
upvoted 0 times
...
Fletcher
25 days ago
B is definitely not an option, just tried it!
upvoted 0 times
...
Javier
1 month ago
Wait, are you sure about that? I thought the wizard always started up.
upvoted 0 times
...
Mabel
1 month ago
Totally agree with A and E!
upvoted 0 times
...
Weldon
1 month ago
I thought restarting would work, but it doesn't.
upvoted 0 times
...
Stephen
2 months ago
A) and E) are the correct options!
upvoted 0 times
...
Janey
2 months ago
I definitely remember that the CLI commands are important here. I think "configure terminal" could be one of the options to start the wizard.
upvoted 0 times
...
Sheldon
2 months ago
I'm not sure about restarting the system. I thought the wizard only appears automatically after the first boot, but maybe there's a way to trigger it?
upvoted 0 times
...
Nada
2 months ago
I think I practiced a similar question where we had to access the configuration wizard manually. I feel like option E might be correct.
upvoted 0 times
...
Krissy
4 months ago
I remember something about using the CLI commands, but I can't recall if it's "config setup" or "adminaccess configure."
upvoted 0 times
...

Save Cancel