Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 350-401 Exam - Topic 7 Question 55 Discussion

Refer to the exhibit.An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEtherenet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two.)
B) Router(config-vrf)#address-family ipv4 and E) Router(config-if)#ip address 192.168.1.1 255.255.255.0
A) Router(config-vrf)#ip address 192.168.1.1 255.255.255.0
C) Router(config-if)#address-family ipv4
D) Router(config-vrf)#address-family ipv6

Cisco 350-401 Exam - Topic 7 Question 55 Discussion

Actual exam question for Cisco's 350-401 exam
Question #: 55
Topic #: 7
[All 350-401 Questions]

Refer to the exhibit.

An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEtherenet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two.)

Show Suggested Answer Hide Answer
Suggested Answer: B, E

by Clorinda at Aug 04, 2022, 09:37 AM

Limited Time Offer

25%

Off

Get Premium 350-401 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Harris
10 months ago
A and E are the right commands, no doubt!
upvoted 0 times
...
Yaeko
10 months ago
I thought you could only assign IPs in the vrf context.
upvoted 0 times
...
Rikki
10 months ago
Wait, why is ipv6 even an option here?
upvoted 0 times
...
Wendell
11 months ago
Definitely E and A!
upvoted 0 times
...
Iluminada
11 months ago
You need to use the ip address command for the interface.
upvoted 0 times
...
Adolph
11 months ago
I remember that the /24 subnet mask translates to 255.255.255.0, so option A seems plausible, but I’m not sure if it’s the right context.
upvoted 0 times
...
Luis
11 months ago
I practiced a similar question, and I think both commands need to be in the interface context. I might go with E and C, but I'm not completely confident.
upvoted 0 times
...
Rebeca
11 months ago
I'm not entirely sure, but I feel like the address-family command is important for specifying the IP version. Could it be option C?
upvoted 0 times
...
Trinidad
11 months ago
I think I remember that the command to assign an IP address is done in interface configuration mode, so maybe option E is correct.
upvoted 0 times
...
Chandra
11 months ago
Hmm, I'm a bit unsure here. The question mentions a scheduling system, so I'm wondering if the Batch Data Synchronization pattern might be more appropriate to ensure the workshop availability is properly updated.
upvoted 0 times
...
Ashlyn
11 months ago
Ah, I remember learning about this in class. The monitor option in Add Data allows for both one-time and continuous monitoring. I'm confident that the correct answer is D.
upvoted 0 times
...
Joanna
11 months ago
I feel like option D could be a factor. It says there were no alerts, which might suggest an undetected vulnerability.
upvoted 0 times
...

Save Cancel