Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 350-401 Exam - Topic 21 Question 57 Discussion

Configure OSPF on both routers according to the topology to achieve these goals:
A) Explanation: Solution: R1 Router ospf 1 Int loop0 Ip ospf 1 area 0 Int et0/0 Ip ospf 1 area 0 Ip ospf network point-to-point Copy run start R2 Router ospf 1 Int loop0 Ip ospf 1 area 0 Int et0/0 Ip ospf 1 area 0 Ip ospf network point-to-point Copy run start Verification:-

Cisco 350-401 Exam - Topic 21 Question 57 Discussion

Actual exam question for Cisco's 350-401 exam
Question #: 57
Topic #: 21
[All 350-401 Questions]

Configure OSPF on both routers according to the topology to achieve these goals:

Show Suggested Answer Hide Answer
Suggested Answer: A

by Rozella at Sep 16, 2022, 09:00 PM

Limited Time Offer

25%

Off

Get Premium 350-401 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Ricarda
10 months ago
I don't know, seems a bit too simple for OSPF.
upvoted 0 times
...
Louvenia
10 months ago
Looks good to me, nice and clean config!
upvoted 0 times
...
Walton
10 months ago
Wait, are you sure about the loopback interface setup?
upvoted 0 times
...
Olga
11 months ago
Totally agree, point-to-point is the way to go!
upvoted 0 times
...
Desmond
11 months ago
OSPF area 0 is correct for both routers.
upvoted 0 times
...
Hoa
11 months ago
I recall that OSPF requires the same area ID on both routers, but I hope I got the syntax right for the commands.
upvoted 0 times
...
Sharee
11 months ago
I’m a bit confused about the point-to-point setting. Is that necessary for both interfaces, or just one?
upvoted 0 times
...
Paris
11 months ago
I practiced a similar question where I had to configure OSPF on two routers, and I think using the loopback interface is important for stability.
upvoted 0 times
...
Bulah
11 months ago
I think I remember that OSPF needs to be enabled on both interfaces, but I'm not sure if I should use area 0 for both routers.
upvoted 0 times
...
Katlyn
11 months ago
This is a good opportunity to apply my knowledge of fully funded health plans. I'll carefully read through the details and options to determine the correct answer.
upvoted 0 times
...
Regenia
11 months ago
My strategy here is to look for the activity type that allows targeted content delivery based on audience insights. That sounds like Experience Targeting to me.
upvoted 0 times
...
Francine
11 months ago
Okay, I've got this. The key is that with a high availability pair, you want the devices to be able to seamlessly take over for each other if one fails. Having the same configuration ensures a smooth failover process and allows application traffic to resume without interruption. I'm confident B is the right answer.
upvoted 0 times
...

Save Cancel