Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 300-815 Exam - Topic 11 Question 40 Discussion

An engineer has temporarily disabled toll fraud prevention for SIP line calls on a Cisco CME12.6x and must enforce security and toll fraud prevention for the SIP line side on Cisco Unified CME. Which configuration must be used to start this process?
D) voice service volp ip address trusted authenticate
A) voice service volp Ip address trusted list
B) voice service volp enablo ip address trust authentication
C) voice service volp enable Ip address trust list

Cisco 300-815 Exam - Topic 11 Question 40 Discussion

Actual exam question for Cisco's 300-815 exam
Question #: 40
Topic #: 11
[All 300-815 Questions]

An engineer has temporarily disabled toll fraud prevention for SIP line calls on a Cisco CME12.6x and must enforce security and toll fraud prevention for the SIP line side on Cisco Unified CME. Which configuration must be used to start this process?

Show Suggested Answer Hide Answer
Suggested Answer: D

by Ceola at May 08, 2022, 11:56 PM

Limited Time Offer

25%

Off

Get Premium 300-815 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Verlene
10 months ago
I agree with Ciara, C seems right!
upvoted 0 times
...
Desire
10 months ago
Wait, is this really how you secure SIP lines? Sounds sketchy.
upvoted 0 times
...
Murray
11 months ago
Definitely not A, that's outdated.
upvoted 0 times
...
Soledad
11 months ago
Nah, I believe it's option D.
upvoted 0 times
...
Ciara
11 months ago
I think it's option C for sure.
upvoted 0 times
...
Keshia
11 months ago
I'm a bit confused on the differences between these risk types. I'll need to review my notes to make sure I understand them properly before answering.
upvoted 0 times
...
Vicki
11 months ago
I'm a bit confused by this question. I know there are commands for managing ext3 filesystems, but I can't recall the specific one for setting the check interval. I'll have to review my notes on filesystem administration to be sure I get this right.
upvoted 0 times
...

Save Cancel