Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 300-710 Exam - Topic 4 Question 58 Discussion

A network administrator registered a new FTD to an existing FMC. The administrator cannot place the FTD in transparent mode. Which action enables transparent mode?
B) Dereglster the FTD device from FMC and configure transparent mode via the CLI.
A) Add a Bridge Group Interface to the FTD before transparent mode is configured.
C) Obtain an FTD model that supports transparent mode.
D) Assign an IP address to two physical interfaces.

Cisco 300-710 Exam - Topic 4 Question 58 Discussion

Actual exam question for Cisco's 300-710 exam
Question #: 58
Topic #: 4
[All 300-710 Questions]

A network administrator registered a new FTD to an existing FMC. The administrator cannot place the FTD in transparent mode. Which action enables transparent mode?

Show Suggested Answer Hide Answer
Suggested Answer: B

by Harrison at Oct 14, 2022, 10:00 AM

Limited Time Offer

25%

Off

Get Premium 300-710 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Alonso
10 months ago
Assigning IPs to interfaces won't help with that.
upvoted 0 times
...
Margurite
10 months ago
Wait, I didn't know some FTD models don't support transparent mode!
upvoted 0 times
...
Alesia
10 months ago
I thought you could just configure it via CLI?
upvoted 0 times
...
Basilia
11 months ago
Totally agree, that's the way to go.
upvoted 0 times
...
Iluminada
11 months ago
You need to add a Bridge Group Interface first!
upvoted 0 times
...
Lynda
11 months ago
I recall that assigning IP addresses to interfaces is usually part of the process, but I’m not clear if that’s necessary for transparent mode specifically.
upvoted 0 times
...
Trina
11 months ago
I’m a bit confused about the requirements for transparent mode. I feel like I read that certain FTD models don’t support it at all.
upvoted 0 times
...
Lili
11 months ago
I think I saw a similar question in practice where it mentioned deregistering the FTD to change modes. That might be an option here too.
upvoted 0 times
...
Nakisha
11 months ago
I remember something about needing to set up a bridge group interface before switching to transparent mode, but I'm not entirely sure if that's the only step.
upvoted 0 times
...
Stevie
11 months ago
Hmm, I'm not entirely sure about this one. I'll need to think it through carefully to make sure I understand the purpose of required fields.
upvoted 0 times
...
Mariko
11 months ago
I think the key here is to focus on the specific wording of the question. It's asking about a business rule that creates a CI from a Vulnerable Item record, so option D seems like the most logical choice. I'll mark that one and move on to the next question.
upvoted 0 times
...
Gearldine
11 months ago
I remember practicing a similar question, and I chose "Control environment," but now I’m questioning if I misremembered the details.
upvoted 0 times
...

Save Cancel