Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 300-620 Exam - Topic 8 Question 57 Discussion

A Cisco ACI endpoint group must have its gateway address migrated out of the ACI fabric. An engineer configures EPG-TEST with a static port binding and configures the encap VLAN with the required VLAN. Which configuration set must be used on the bridge domain to meet these requirements?
A) L2 Unknown Unicast: Hardware Proxy Unicast Routing: Disabled ARP Flooding: Enabled
B) L2 Unknown Unicast: Hardware Proxy Unicast Routing: Disabled ARP Flooding: Disabled
C) L2 Unknown Unicast: Flood Unicast Routing: Disabled ARP Flooding: Enabled
D) L2 Unknown Unicast: Flood Unicast Routing: Enabled ARP Flooding: Enabled

Cisco 300-620 Exam - Topic 8 Question 57 Discussion

Actual exam question for Cisco's 300-620 exam
Question #: 57
Topic #: 8
[All 300-620 Questions]

A Cisco ACI endpoint group must have its gateway address migrated out of the ACI fabric. An engineer configures EPG-TEST with a static port binding and configures the encap VLAN with the required VLAN. Which configuration set must be used on the bridge domain to meet these requirements?

Show Suggested Answer Hide Answer
Suggested Answer: A

by Ashlyn at May 25, 2023, 08:04 AM

Limited Time Offer

25%

Off

Get Premium 300-620 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Adolph
10 months ago
Not sure about B, seems risky with ARP Flooding disabled.
upvoted 0 times
...
Johanna
10 months ago
Definitely going with A, it fits the requirements perfectly.
upvoted 0 times
...
Ahmed
10 months ago
Surprised that ARP Flooding is even an option!
upvoted 0 times
...
Aliza
11 months ago
I disagree, I think C is the better choice here.
upvoted 0 times
...
Man
11 months ago
Option A seems right for static port binding.
upvoted 0 times
...
Jacqueline
11 months ago
I vaguely remember that hardware proxy might be useful for handling unknown unicast traffic, but I’m not confident about which option fits best here.
upvoted 0 times
...
Svetlana
11 months ago
I’m a bit confused about the unicast routing setting. I feel like it should be disabled, but I can't recall the exact implications of that.
upvoted 0 times
...
Ressie
11 months ago
I think we practiced a similar question where enabling ARP flooding was necessary, so I might lean towards option A or C.
upvoted 0 times
...
Muriel
11 months ago
I remember discussing how ARP flooding is important for endpoints outside the ACI fabric, but I'm not sure if it should be enabled or disabled in this case.
upvoted 0 times
...
Malcolm
11 months ago
Hmm, I'm a bit unsure about the Path-ID details. I'll need to review my notes on BGP to make sure I understand this properly.
upvoted 0 times
...
Lakeesha
11 months ago
I'm feeling good about this one. The two quantitative job evaluation methods are job component and point factor. I'm confident that's the right answer.
upvoted 0 times
...
Sabra
11 months ago
Hmm, I'm a bit unsure about this one. I know SSL/TLS uses certificates, but I'm not 100% certain that's the right answer.
upvoted 0 times
...

Save Cancel