Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Cisco 300-615 Exam - Topic 7 Question 121 Discussion

Refer to the exhibit.An engineer configures the server port on a Cisco Nexus 5000 Series Switch. The switch connects to an NPV edge switch port. The server fails to send the FC traffic to the fabric. Which action resolves the issue?
B) Match the VSAN membership on both ends of the connection.
A) Enable the NPIV mode on the Cisco Nexus 5000 switch.
C) Configure the BB_credit buffer on the uplink port.
D) Replace the SFP in slot fc2/12.

Cisco 300-615 Exam - Topic 7 Question 121 Discussion

Actual exam question for Cisco's 300-615 exam
Question #: 121
Topic #: 7
[All 300-615 Questions]

Refer to the exhibit.

An engineer configures the server port on a Cisco Nexus 5000 Series Switch. The switch connects to an NPV edge switch port. The server fails to send the FC traffic to the fabric. Which action resolves the issue?

Show Suggested Answer Hide Answer
Suggested Answer: B

Contribute your Thoughts:

0/2000 characters
Quentin
3 days ago
D is unlikely. Replacing hardware should be a last resort.
upvoted 0 times
...
Hubert
8 days ago
C could be a factor too, but I lean towards B.
upvoted 0 times
...
Ricki
13 days ago
I disagree, B seems more logical. VSAN membership must match.
upvoted 0 times
...
Ernestine
19 days ago
I think option A is the best choice. NPIV mode is crucial for FC traffic.
upvoted 0 times
...
Oliva
24 days ago
I feel like D is a bit extreme. Replacing hardware should be a last resort.
upvoted 0 times
...
Chandra
29 days ago
Option C could help, but I doubt it’s the main issue here.
upvoted 0 times
...
Glenna
1 month ago
I’m leaning towards B. VSAN matching is often the root cause of these issues.
upvoted 0 times
...
Justine
1 month ago
I think option A is the best choice. NPIV mode is crucial for FC traffic.
upvoted 0 times
...
Rikki
1 month ago
D is unlikely, if the server isn’t sending traffic, it’s probably a config issue.
upvoted 0 times
...
Wenona
2 months ago
C could be a factor too, but I feel like it’s more about the configuration.
upvoted 0 times
...
Darrin
2 months ago
I disagree, B seems more relevant. VSAN membership is key for connectivity.
upvoted 0 times
...
Teresita
2 months ago
I think option A is the best choice. NPIV mode is crucial for FC traffic.
upvoted 0 times
...
Coral
2 months ago
D seems a bit extreme, replacing hardware might not be necessary.
upvoted 0 times
...
Thaddeus
2 months ago
Nah, C is the way to go, buffer settings matter.
upvoted 0 times
...
Fannie
4 months ago
Surprised this is even an issue, thought it was straightforward!
upvoted 0 times
...
Avery
4 months ago
I think A could also work, NPIV is important.
upvoted 0 times
...
Pa
4 months ago
Definitely B, matching VSANs is crucial.
upvoted 0 times
...
Val
4 months ago
Agreed, B is the most logical choice here.
upvoted 0 times
...
Delsie
5 months ago
No way, D is a waste of time, it's not the SFP.
upvoted 0 times
...
Glory
5 months ago
Surprised this is even an issue, shouldn't FC just flow?
upvoted 0 times
...
Louis
5 months ago
I think A could work too, NPIV is important.
upvoted 0 times
...
Natalie
5 months ago
Definitely B, matching VSANs is crucial.
upvoted 0 times
...
Lynelle
5 months ago
Replacing the SFP seems like a last resort. I hope we don't need to go that route if it's just a configuration issue.
upvoted 0 times
...
Louisa
5 months ago
I feel like configuring the BB_credit buffer could help, but I can't recall if it directly affects FC traffic.
upvoted 0 times
...
Romana
6 months ago
I remember a practice question where matching VSAN memberships was crucial for connectivity. That could be the key here too.
upvoted 0 times
...
Cherri
6 months ago
I think enabling NPIV mode might be the right choice, but I'm not completely sure if that's the only thing we need to check.
upvoted 0 times
...

Save Cancel