Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 300-615 Exam - Topic 3 Question 125 Discussion

Refer to the exhibit.The vPC neighborship between two switches is in suspended state. Which configuration change resolves the issue and brings up the vPC neighborship?
C) Configure QoS MTU value of 9216 on the peer switch
A) Change STP Port Type to Network on the peer switch
B) Enable Bridge Assurance on the local switches
D) Add VLAN 400-401 to the configuration on the local switch

Cisco 300-615 Exam - Topic 3 Question 125 Discussion

Actual exam question for Cisco's 300-615 exam
Question #: 125
Topic #: 3
[All 300-615 Questions]

Refer to the exhibit.

The vPC neighborship between two switches is in suspended state. Which configuration change resolves the issue and brings up the vPC neighborship?

Show Suggested Answer Hide Answer
Suggested Answer: C

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/troubleshooting/guide/N5K_Troubleshooting_Guide/n5K_ts_vpc.pdf

by Ariel at May 16, 2026, 03:01 PM

Limited Time Offer

25%

Off

Get Premium 300-615 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Jesusita
3 days ago
I think option A is the best choice. Network port type is crucial.
upvoted 0 times
...
Dawne
8 days ago
Adding VLANs seems unnecessary for this issue.
upvoted 0 times
...
Tonette
13 days ago
I thought enabling Bridge Assurance was the way to go.
upvoted 0 times
...
Refugia
19 days ago
Wait, isn’t it more complicated than just that?
upvoted 0 times
...
Juan
24 days ago
Totally agree, that’s the right move!
upvoted 0 times
...
Refugia
29 days ago
A) Change STP Port Type to Network on the peer switch is the fix.
upvoted 0 times
...
Leah
1 month ago
Nah, I doubt that will work.
upvoted 0 times
...
Tanja
1 month ago
I think D) Add VLAN 400-401 is also a possible solution.
upvoted 0 times
...
Julian
1 month ago
Wait, is it really that simple?
upvoted 0 times
...
Selma
2 months ago
Totally agree, that’s the right move!
upvoted 0 times
...
Horace
2 months ago
A) Change STP Port Type to Network on the peer switch is the fix.
upvoted 0 times
...
Brianne
2 months ago
I'm leaning towards changing the STP Port Type, but I can't quite remember if that's the right move for a suspended state.
upvoted 0 times
...
Cecil
2 months ago
I practiced a similar question where VLAN configuration was key, so maybe adding VLANs could resolve the issue here too.
upvoted 0 times
...
Ciara
2 months ago
I think enabling Bridge Assurance could help, but I also recall something about STP settings being crucial for vPC.
upvoted 0 times
...
Twana
4 months ago
I remember studying vPC configurations, but I'm not entirely sure which option directly affects the neighborship state.
upvoted 0 times
...

Save Cancel