Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 300-420 Exam - Topic 12 Question 54 Discussion

Refer to the exhibit. An architect must design a solution to connect the two ASs. To optimize bandwidth, the design will implement load sharing between router R6 and router R4. Which solution should the design include?
D) Use maximum-paths to install multiple paths in the routing table.
A) Use update-source to specify the Loopback interface.
B) Use next-hop-serf attributes only for routes that are learned from eBGP peers.
C) Configure the eBGP TTL to support eBGP multihop.

Cisco 300-420 Exam - Topic 12 Question 54 Discussion

Actual exam question for Cisco's 300-420 exam
Question #: 54
Topic #: 12
[All 300-420 Questions]

Refer to the exhibit. An architect must design a solution to connect the two ASs. To optimize bandwidth, the design will implement load sharing between router R6 and router R4. Which solution should the design include?

Show Suggested Answer Hide Answer
Suggested Answer: D

by Sheron at Jun 13, 2022, 03:50 PM

Limited Time Offer

25%

Off

Get Premium 300-420 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Krystal
10 months ago
I’ve heard mixed things about eBGP multihop, not convinced it’s necessary.
upvoted 0 times
...
Broderick
10 months ago
Option A seems interesting too, but not sure if it’s the right fit here.
upvoted 0 times
...
Lindsay
10 months ago
Wait, can you really use multiple paths like that? Sounds risky.
upvoted 0 times
...
Denny
11 months ago
Totally agree, maximum-paths is key for optimizing bandwidth!
upvoted 0 times
...
Dell
11 months ago
I think option D is the best choice for load sharing.
upvoted 0 times
...
Josephine
11 months ago
I definitely remember that using next-hop-self is important for eBGP, but I'm not sure if it applies here since the question focuses on load sharing.
upvoted 0 times
...
Martina
11 months ago
I'm a bit confused about the eBGP multihop configuration. I feel like it might be relevant, but I can't recall the specifics.
upvoted 0 times
...
Britt
11 months ago
I remember practicing a question similar to this where we had to optimize bandwidth, and I think update-source was mentioned as a good option.
upvoted 0 times
...
Jesusita
11 months ago
I think using maximum-paths could be the right choice since it allows for load balancing, but I'm not entirely sure if it applies to this scenario.
upvoted 0 times
...
Paris
11 months ago
Vulnerability assessment seems like the most logical choice here. That would give us a clear picture of the risks and help us prioritize the security controls.
upvoted 0 times
...
Anjelica
11 months ago
Power Virtual Agents seems like overkill for this scenario. I'd focus on the sales-oriented apps to coordinate with my colleagues.
upvoted 0 times
...
Margart
11 months ago
I vaguely recall something about full regression tests being crucial for any major update. Does that mean option D might be the best choice?
upvoted 0 times
...

Save Cancel