Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Amazon ANS-C01 Exam - Topic 1 Question 1 Discussion

Your organization has a newly installed 1-Gbps AWS Direct Connect connection. You order the cross-connect from the Direct Connect location provider to the port on your router in the same facility. To enable the use of your first virtual interface, your router must be configured appropriately.What are the minimum requirements for your router?
B) 1-Gbps Single Mode Fiber Interface, 802.1Q VLAN, Peer IP Address, BGP Session with MD5.
A) 1-Gbps Multi Mode Fiber Interface, 802.1Q VLAN, Peer IP Address, BGP Session with MD5.
C) IPsec Parameters, Pre-Shared key, Peer IP Address, BGP Session with MD5
D) BGP Session with MD5, 802.1Q VLAN, Route-Map, Prefix List, IPsec encrypted GRE Tunnel

Amazon ANS-C01 Exam - Topic 1 Question 1 Discussion

Actual exam question for Amazon's ANS-C01 exam
Question #: 1
Topic #: 1
[All ANS-C01 Questions]

Your organization has a newly installed 1-Gbps AWS Direct Connect connection. You order the cross-connect from the Direct Connect location provider to the port on your router in the same facility. To enable the use of your first virtual interface, your router must be configured appropriately.

What are the minimum requirements for your router?

Show Suggested Answer Hide Answer
Suggested Answer: B

Contribute your Thoughts:

0/2000 characters
Ceola
10 months ago
1-Gbps? I thought they were all 10-Gbps now!
upvoted 0 times
...
Alline
10 months ago
Wait, why would you need IPsec for this? Seems off.
upvoted 0 times
...
Regenia
10 months ago
BGP Session with MD5 is a must-have!
upvoted 0 times
...
Stephaine
11 months ago
I think it's actually single mode fiber for better distance.
upvoted 0 times
...
Myra
11 months ago
Definitely need that 802.1Q VLAN for sure.
upvoted 0 times
...
Artie
11 months ago
I don't think IPsec is necessary for this scenario, so I’m pretty sure it’s not C or D, but I’m still confused about the fiber interface requirements.
upvoted 0 times
...
Vicki
11 months ago
I feel like the answer might be A or B, but I’m leaning towards A since multi-mode fiber seems more common in these setups.
upvoted 0 times
...
Dorethea
11 months ago
I remember practicing a question about BGP sessions, and I think MD5 is important for authentication, but I can't recall the specifics about the fiber type.
upvoted 0 times
...
Herman
11 months ago
I think the router needs to support 802.1Q VLAN tagging, but I'm not sure about the fiber interface type.
upvoted 0 times
...
Kizzy
11 months ago
I feel like the answer has to include the VLAN and BGP session, but I can't recall if we need a route-map or prefix list for this specific scenario.
upvoted 0 times
...
Lai
11 months ago
I’m a bit confused about whether we need IPsec parameters for this setup. I thought it was more about the direct connection itself.
upvoted 0 times
...
Shelia
11 months ago
I remember practicing a question about BGP sessions and MD5 authentication, so I feel like that’s definitely a requirement here.
upvoted 0 times
...
Laurel
11 months ago
I think the router needs to support 802.1Q VLAN tagging, but I'm not sure about the fiber type. Was it multi-mode or single-mode?
upvoted 0 times
...
Kimberely
11 months ago
Hmm, I'm a bit confused by the EVPN terminology here. I'll need to refresh my memory on the different EVPN route types before I can confidently answer this.
upvoted 0 times
...
Krissy
11 months ago
Hmm, there are a lot of steps here. I better read through the instructions a few times to make sure I don't miss anything.
upvoted 0 times
...
Adelina
11 months ago
The wording of the answers is tripping me up a bit. I'll need to re-read the question and options slowly to make sure I understand the nuances.
upvoted 0 times
...

Save Cancel