Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

SAS A00-215 Exam - Topic 12 Question 17 Discussion

How many statements are in the following PROC PRINT step?
C) 4
A) 5
B) 3
D) 1

SAS A00-215 Exam - Topic 12 Question 17 Discussion

Actual exam question for SAS's A00-215 exam
Question #: 17
Topic #: 12
[All A00-215 Questions]

How many statements are in the following PROC PRINT step?

Show Suggested Answer Hide Answer
Suggested Answer: C

by Cheryl at May 07, 2022, 07:47 AM

Limited Time Offer

25%

Off

Get Premium A00-215 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Ling
10 months ago
I see 5 statements, but I might be overthinking it.
upvoted 0 times
...
Pa
10 months ago
Wait, are we sure it's not just 1? Seems too simple!
upvoted 0 times
...
Coral
11 months ago
I think it's 3, though. Did I miss something?
upvoted 0 times
...
Alberta
11 months ago
Totally agree, it's definitely 4!
upvoted 0 times
...
Herminia
11 months ago
I counted 4 statements in that PROC PRINT step.
upvoted 0 times
...
Pok
11 months ago
I remember there being a single main statement in PROC PRINT, so maybe it's 1? But I need to double-check that.
upvoted 0 times
...
Kallie
11 months ago
I’m leaning towards 5 statements, but I could be mixing it up with another PROC step we covered.
upvoted 0 times
...
Monte
11 months ago
I practiced a similar question last week, and I feel like the answer might be 3. I just can't recall the exact details.
upvoted 0 times
...
Joseph
11 months ago
I think there are 4 statements, but I'm not entirely sure. I remember something about counting options in PROC PRINT.
upvoted 0 times
...
Leandro
11 months ago
Wait, do I need to do this all in one step? Or can I remove them individually? I want to make sure I get this right.
upvoted 0 times
...
Felicidad
12 months ago
Hmm, I'm a bit unsure about this one. I know we need to configure something to allow the non-optimized data paths, but I'm not sure if it's a port set or switch zoning. I'll need to think this through carefully.
upvoted 0 times
...

Save Cancel