Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

RedHat EX200 Exam - Topic 1 Question 3 Discussion

Configure the system synchronous as 172.24.40.10.
A) Graphical Interfaces:
B) Graphical Interfaces:

RedHat EX200 Exam - Topic 1 Question 3 Discussion

Actual exam question for RedHat's EX200 exam
Question #: 3
Topic #: 1
[All EX200 Questions]

Configure the system synchronous as 172.24.40.10.

Show Suggested Answer Hide Answer
Suggested Answer: A

by Vallie at May 08, 2022, 10:34 PM

Limited Time Offer

25%

Off

Get Premium EX200 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Leana
10 months ago
Yup, definitely need to set it up like that!
upvoted 0 times
...
Yan
10 months ago
Just to confirm, this is for the main server, right?
upvoted 0 times
...
Sheron
11 months ago
Wait, are we sure that's the right address?
upvoted 0 times
...
Lawrence
11 months ago
Totally agree, 172.24.40.10 is the way to go.
upvoted 0 times
...
Marisha
11 months ago
That's the correct IP for sync!
upvoted 0 times
...
Annabelle
11 months ago
I vaguely recall that we might need to check the firewall settings too, just in case the NTP packets are being blocked.
upvoted 0 times
...
Donette
11 months ago
I’m a bit confused about whether this is done through a command line or a graphical interface. I feel like I’ve seen both options in our labs.
upvoted 0 times
...
Lashawnda
11 months ago
This seems similar to a practice question we did on configuring NTP servers. I think we just had to specify the server IP in the config file.
upvoted 0 times
...
Marshall
11 months ago
I think I remember configuring the system time using the NTP service, but I'm not entirely sure how to set it to a specific IP like 172.24.40.10.
upvoted 0 times
...
Osvaldo
11 months ago
I'm a little unsure about this one. I know the Workspace ONE UEM API is used for administration and maintenance, but I'm not entirely clear on the specific capabilities. I'll need to review my notes and maybe even look up some additional resources to make sure I understand this properly.
upvoted 0 times
...
Marshall
11 months ago
I think this is about identifying a non-benefit of emergency follow-up. My first strategy is to read each option carefully and look for what seems out of place.
upvoted 0 times
...

Save Cancel