Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Qlik QV12BA Exam - Topic 4 Question 36 Discussion

Actual exam question for Qlik's QV12BA exam
Question #: 36
Topic #: 4
[All QV12BA Questions]

For a gauge, in which two places in the chart properties can expressions be entered? (Select two )

Show Suggested Answer Hide Answer
Suggested Answer: B, D

by Helene at May 06, 2022, 12:43 PM

Limited Time Offer

25%

Off

Get Premium QV12BA Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Aleta
7 months ago
I thought X and Y position could also take expressions, but I guess not!
upvoted 0 times
...
Ula
7 months ago
Yup, definitely Show Condition and Calculation Condition.
upvoted 0 times
...
Hortencia
7 months ago
Wait, are you sure about that? I thought it was different.
upvoted 0 times
...
Claribel
7 months ago
Totally agree, those are the right spots!
upvoted 0 times
...
Nichelle
7 months ago
You can enter expressions in Show Condition and Calculation Condition.
upvoted 0 times
...
Jolene
8 months ago
I’m leaning towards Show Condition and Calculation Condition as the right answers, but I wish I had reviewed this topic more thoroughly.
upvoted 0 times
...
Marilynn
8 months ago
I feel like X and Y position might be a place for expressions, but it seems more about layout than conditions.
upvoted 0 times
...
Bulah
8 months ago
I remember practicing a question similar to this, and I think Auto Minimize was one of the options, but I can't recall the second one.
upvoted 0 times
...
Gracie
8 months ago
I think expressions can be entered in the Show Condition and Calculation Condition properties, but I'm not entirely sure.
upvoted 0 times
...
Wendell
8 months ago
Hmm, I'm not entirely sure what "pluggable modularity" means in the context of consensus algorithms. I'll have to read the question again and see if I can find any clues.
upvoted 0 times
...
Jennifer
8 months ago
This seems like a straightforward question about symbolizing features in ArcGIS. I think the key is to make sure the cliff and escarpment features are drawn on top of the contour features, so I'll try option B and use symbol level drawing to control the order.
upvoted 0 times
...

Save Cancel