Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Nutanix NCP-CI-AWS Exam - Topic 4 Question 41 Discussion

Refer to the exhibit.An administrator has deployed an NC2 cluster on AWS and selected "I want to protect the cluster" option for Cluster Protect, as shown in the exhibit. The cluster is licensed with NCI Ultimate and has been deployed with AOS 6.8.What additional steps should the administrator take to complete the deployment?
C) Configure Cluster Protect after the deployment completes.
A) Upgrade the Cluster AOS version to 7 or higher.
B) Purchase the Data Protection add-on for NCI.
D) Deploy the Cluster Protect solution from AWS Marketplace.

Nutanix NCP-CI-AWS Exam - Topic 4 Question 41 Discussion

Actual exam question for Nutanix's NCP-CI-AWS exam
Question #: 41
Topic #: 4
[All NCP-CI-AWS Questions]

Refer to the exhibit.

An administrator has deployed an NC2 cluster on AWS and selected "I want to protect the cluster" option for Cluster Protect, as shown in the exhibit. The cluster is licensed with NCI Ultimate and has been deployed with AOS 6.8.

What additional steps should the administrator take to complete the deployment?

Show Suggested Answer Hide Answer
Suggested Answer: C

by Tonette at May 28, 2026, 06:41 PM

Limited Time Offer

25%

Off

Get Premium NCP-CI-AWS Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Marta
3 days ago
I’m leaning towards option D, deploying from AWS Marketplace, but I’m not confident if that’s the right next step after selecting the protection option.
upvoted 0 times
...
Joye
8 days ago
I feel like there was a practice question that mentioned upgrading the AOS version to 7 for full functionality, but I can't recall the specifics.
upvoted 0 times
...
Willodean
13 days ago
I think I remember something about needing to configure Cluster Protect after the initial setup, but I'm not entirely sure if that's the only step needed.
upvoted 0 times
...

Save Cancel