Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Nokia 4A0-113 Exam - Topic 2 Question 3 Discussion

When an OSPF adjacency is stuck in the "ExchStart" state, what is the most likely cause?
A) The MTU does not match on both interfaces
B) OSPF is not enabled on one of the routers
C) The Router ID is the same on both routers
D) A OSPF Hello has not been received from the neighbor

Nokia 4A0-113 Exam - Topic 2 Question 3 Discussion

Actual exam question for Nokia's 4A0-113 exam
Question #: 3
Topic #: 2
[All 4A0-113 Questions]

When an OSPF adjacency is stuck in the "ExchStart" state, what is the most likely cause?

Show Suggested Answer Hide Answer
Suggested Answer: A

by Nickolas at May 04, 2022, 06:27 AM

Limited Time Offer

25%

Off

Get Premium 4A0-113 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Nieves
10 months ago
OSPF not enabled? Nah, that’s too basic to cause this.
upvoted 0 times
...
Marquetta
10 months ago
Wait, are you saying OSPF can get stuck just because of MTU?
upvoted 0 times
...
Pamella
10 months ago
Same Router ID is a common mistake too!
upvoted 0 times
...
Salina
11 months ago
I disagree, it could also be the Hello packets issue.
upvoted 0 times
...
Geoffrey
11 months ago
Definitely the MTU mismatch, seen it happen a lot.
upvoted 0 times
...
Juan
11 months ago
I recall that if a Hello packet isn't received, it can lead to adjacency issues, but I can't remember if that directly ties to ExchStart.
upvoted 0 times
...
Evelynn
11 months ago
I think I came across a practice question where OSPF adjacency was affected by the Router ID being the same. That might be relevant here too.
upvoted 0 times
...
Deangelo
11 months ago
I remember studying that the MTU mismatch can definitely cause issues, but I'm not entirely sure if it's the only reason for being stuck in ExchStart.
upvoted 0 times
...
Laurel
11 months ago
I feel like OSPF not being enabled on one of the routers could be a cause, but I’m not confident if it specifically relates to the ExchStart state.
upvoted 0 times
...
Pedro
11 months ago
If there's a PSP option that already supports controllers, that could be the easiest path forward. Avoiding the conversion work altogether would be ideal if possible.
upvoted 0 times
...
Freeman
11 months ago
Okay, I remember that regular ADDM uses AWR snapshots, but I can't recall if those are the latest snapshots or ones that have already been purged. I'll have to read the options carefully.
upvoted 0 times
...

Save Cancel