Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Nokia 4A0-105 Exam - Topic 1 Question 36 Discussion

Which of the following describes the setting of the l-SID on the Alcatel-Lucent 7750 SR?
C) The I-SID is set to the service-id, unless the service-id is larger than a 24 bit value. In this case the I-SID must be explicitly configured.
A) The I-SID is set to 0 by default and is only used for interop purposes. The receiving PE uses the service label to determine the I-VPLS.
B) There is no default value. The I-SID must always be explicitly configured
D) The I-SID is always set to the service-id by default.

Nokia 4A0-105 Exam - Topic 1 Question 36 Discussion

Actual exam question for Nokia's 4A0-105 exam
Question #: 36
Topic #: 1
[All 4A0-105 Questions]

Which of the following describes the setting of the l-SID on the Alcatel-Lucent 7750 SR?

Show Suggested Answer Hide Answer
Suggested Answer: C

by Shonda at May 07, 2022, 10:55 PM

Limited Time Offer

25%

Off

Get Premium 4A0-105 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Theola
7 months ago
I thought the I-SID was always the service-id by default. Confusing!
upvoted 0 times
...
Flo
7 months ago
Definitely option C, makes the most sense.
upvoted 0 times
...
Lou
7 months ago
Wait, so the I-SID can be the service-id unless it's over 24 bits? That's new to me!
upvoted 0 times
...
Tambra
8 months ago
Nah, I believe it must always be configured explicitly.
upvoted 0 times
...
Benedict
8 months ago
I think the I-SID is set to 0 by default for interop.
upvoted 0 times
...
Berry
8 months ago
I believe the I-SID is set to the service-id by default, but I can't recall if there are exceptions for larger values.
upvoted 0 times
...
Vinnie
8 months ago
I’m really uncertain about whether the I-SID needs to be configured explicitly or if it defaults to something.
upvoted 0 times
...
Yuette
8 months ago
I think I remember that the I-SID has a default value, but I'm not sure if it's always set to 0 or something else.
upvoted 0 times
...
Selma
8 months ago
I practiced a question similar to this, and I feel like the I-SID is tied to the service-id unless it's too large.
upvoted 0 times
...
Jarvis
8 months ago
This looks straightforward - I think I can handle this. The key is to break down the request and add the dimensions I need.
upvoted 0 times
...
Rebecka
8 months ago
This Snort rule looks pretty straightforward. I think I can interpret it without too much trouble.
upvoted 0 times
...
Chantay
8 months ago
Hmm, I'm not sure about this one. I'll have to think it through carefully. Maybe I should review the material on contact center functionality again.
upvoted 0 times
...

Save Cancel