Free Juniper JN0-682 Exam Dumps and JN0-682 Exam Questions

Question No: 1

MultipleChoice

Exhibit.

Referring to the exhibit, which two statements are correct? (Choose two.)

Options

AThe local leaf is using the 192.168.100.102 IP address as the local anchor point of the VTEP tunnel.

BThe remote leaf is using the 192.168.100.102 IP address as the local anchor point of the VTEP tunnel.

CThe remote leaf is using the 192.168.100.101 IP address as the local anchor point of the VTEP tunnel.

DThe local leaf is using the 192.168.100.101 IP address as the local anchor point of the VTEP tunnel.

Question No: 2

MultipleChoice

Exhibit.

Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down.

Referring to the exhibit, which statement is correct?

Options

AType-1 routes for each VM will expire one at a time.

BType-1 routes for all VMs in the site will expire all at once.

CType-1 routes for all VMs in the site will be withdrawn all at once.

DType-1 routes for each VM will be withdrawn one at a time.

Question No: 3

MultipleChoice

Exhibit.

Referring to the exhibit, what happens when you initiate ZTP on a QFX5120 switch running Junos 21.3R1.9?

Options

AZTP skips both the Junos installation and the configuration.

BZTP performs the Junos installation but skips the configuration.

CZTP performs both the Junos installation and the configuration.

DZTP skips the Junos installation but applies the configuration.

Question No: 4

MultipleChoice

Exhibit.

You administer an EVPN-VXLAN fabric. You notice that there is no VXLAN traffic forwarding through the network.

Referring to the exhibit, which modification will solve the problem?

Options

Aset firewall family inet filter allow-BGP term 1 from protocol udp set firewall family inet filter allow-BGP term 1 from destination-port 4789

Bset interfaces et-0/0/49 unit 0 family vxlan

Cset interfaces et-0/0/49 unit 0 family vpls

Dset firewall family inet filter allow-BGP term 1 from protocol tcp set firewall family inet filter allow-BGP term 1 from destination-port 4789

Question No: 5

MultipleChoice

Exhibit.

You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1's VRF-1 to its INSPECT-VRF. however, the traffic is not reaching service L2.

Referring to the exhibit, which two steps should you take to troubleshoot the problem? (choose two.)

Options

AExamine the INSPECT-VRF.evpn 0 route table on L1 for a default route that will direct the traffic to L2.

BExamine the INSPECT-VRF.inet. 0 route table on L1 for a default route that will direct the traffic to L2.

CEnsure that VRF-1 and INSPECT-VRF route targets on L1 and L2 match.

DEnsure that the route target in the INSPECT-VRF of L1 matches the route target of the INSPECT-VRF of L2.

Question No: 6

MultipleChoice

Exhibit.

Referring to the exhibit, you must advertise the Io0.12 interface as a type-5 route.

Which configuration parameter would be used to accomplish this task?

Options

AConfigure auto-export under the routing instance.

BConfigure a vrf-export policy to advertise the interface route under the routing instance.

CConfigure an export policy to advertise the interface route under protocols evpn.

DConfigure vrf-table-label under the routing instance.

Question No: 7

MultipleChoice

Exhibit.

A VXLAN has been created between devices leaf1 and Ieaf3.

Referring to the exhibit, which statement is true?

Options

ATraffic sent from host1 to host2 will be dropped on Ieaf3.

BTraffic sent from host1 to host2 will be tagged with VLAN ID 100 when exiting Ieaf3.

CTraffic sent from host1 to host2 will be tagged with VLAN ID 200 when exiting Ieaf3.

DTraffic sent from host1 to host2 will be dropped on leaf1.

Question No: 8

MultipleChoice

Exhibit.

You choose the EBGP design shown in the exhibit as your IP fabric design. You must ensure that both routes received by the spine nodes will be used for ECMP forwarding

Which BGP parameter would need to be added to the EBGP configuration of the spine nodes to achieve this goal?

Options

Amultipath

Bmultihop

Cadd-path

Dmultipath multiple-as

Question No: 9

MultipleChoice

Exhibit.

You are troubleshooting a connectivity issue across a VXLAN overlay network. In the exhibit, you are using the ping overlay command from a local VTEP residing on a OFX 5120 to a remote VTEP residing on a separate QFX5120.

What is the problem in this situation?

Options

AThe VXLAN controller is down.

BVXLAN VN1100 is not configured on the local VTEP

CVXLAN VN1100 is not configured on the remote VTEP.

DVXLAN VN1100 is not configured on both end points.

Question No: 10

MultipleChoice

Exhibit.

You are troubleshooting a problem with traffic not reaching a remote VTEP

Referring to the exhibit, what is the reason for the problem?

Options

AA conflict exists with the VLAN-to-VNI mapping.

BThe local VTEP is misconfigured with the wrong VNI.

CNo VTEP is configured on peer 192.0.2.20.

DThe remote VTEP does not have the correct VNI configured.