Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

ISTQB ATTA Exam - Topic 3 Question 62 Discussion

Based on the state diagram above, how many invalid test cases could be identified in a state table? 2 credits [K3]
A) 10
B) 12
C) 14
D) 15

ISTQB ATTA Exam - Topic 3 Question 62 Discussion

Actual exam question for ISTQB's ATTA exam
Question #: 62
Topic #: 3
[All ATTA Questions]

Based on the state diagram above, how many invalid test cases could be identified in a state table? 2 credits [K3]

Show Suggested Answer Hide Answer
Suggested Answer: A

by Rozella at Dec 27, 2022, 04:31 PM

Limited Time Offer

25%

Off

Get Premium ATTA Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Elenor
8 months ago
I disagree, I see more than 12 invalid cases.
upvoted 0 times
...
Catalina
8 months ago
Wait, 10 seems too low, right?
upvoted 0 times
...
Dorathy
9 months ago
Not sure about that, could be 15.
upvoted 0 times
...
Rosendo
9 months ago
Definitely 14!
upvoted 0 times
...
Dalene
9 months ago
I think it's 12.
upvoted 0 times
...
Rebbeca
9 months ago
I thought we learned that the maximum could be 15 invalid cases, but I’m not entirely confident about that.
upvoted 0 times
...
Alecia
9 months ago
I feel like there might be 14 invalid cases based on the transitions shown, but I could be mixing it up with another example we did.
upvoted 0 times
...
Quiana
9 months ago
I think we practiced a similar question where we had to count invalid transitions. I want to say the answer was around 12, but I can't recall exactly.
upvoted 0 times
...
Stephen
9 months ago
I remember we discussed how to identify invalid test cases, but I'm not sure how to apply it to this specific diagram.
upvoted 0 times
...
Allene
9 months ago
I'm a bit unsure about this one. Should I go with statement testing to make sure all the calculations are correct, or is equivalence partitioning a better approach? I'll need to think this through carefully.
upvoted 0 times
...
Reuben
10 months ago
SNMP is for network monitoring, so that's probably not the right answer. I'm leaning towards SAML or NetIM as the best options.
upvoted 0 times
...

Save Cancel