New Year Sale 2026! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Huawei H35-911 Exam - Topic 3 Question 8 Discussion

Actual exam question for Huawei's H35-911 exam
Question #: 8
Topic #: 3
[All H35-911 Questions]

Which of the following is not an indoor operation?

Show Suggested Answer Hide Answer
Suggested Answer: B

by Matthew at May 08, 2022, 05:20 PM

Limited Time Offer

25%

Off

Get Premium H35-911 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Sharmaine
4 months ago
I thought cable installation could be both, but yeah, A is outside for sure.
upvoted 0 times
...
Leoma
4 months ago
B and C are definitely indoor, no doubt about it.
upvoted 0 times
...
Lashaunda
4 months ago
Wait, are we sure about that? What if they do it indoors sometimes?
upvoted 0 times
...
Evelynn
4 months ago
Agreed, A is the right choice!
upvoted 0 times
...
Barabara
5 months ago
Definitely A, antenna alignment is done outside.
upvoted 0 times
...
Goldie
5 months ago
I feel like the 19-inch equipment rack installation is clearly indoor, but I keep second-guessing myself on the other options.
upvoted 0 times
...
Arthur
5 months ago
I'm a bit confused about cable installation and wire laying; it could be indoors or outdoors depending on the context, right?
upvoted 0 times
...
Solange
5 months ago
I remember practicing a question about indoor vs outdoor tasks, and I think power on the indoor equipment is definitely an indoor operation.
upvoted 0 times
...
Vicente
5 months ago
I think antenna alignment on the tower is definitely not an indoor operation, but I'm not completely sure.
upvoted 0 times
...
Ben
5 months ago
This seems like a straightforward question about factors that influence management's decision to hire contractors for control evaluations. I'll carefully read through the options and think about which one is the most relevant.
upvoted 0 times
...
Enola
5 months ago
I think the answer is B. The question is asking for the PROC FREQ step that creates the frequency report, and the code in option B looks like it would generate a two-way frequency table for the "make" and "drivetrain" variables.
upvoted 0 times
...
Fanny
5 months ago
Hmm, I'm a bit confused by the options here. I'll need to think through the Hive architecture in more detail to figure out which one is the correct answer.
upvoted 0 times
...

Save Cancel