Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Huawei Exam H35-260 Topic 1 Question 31 Discussion

Actual exam question for Huawei's H35-260 exam
Question #: 31
Topic #: 1
[All H35-260 Questions]

Which of the following conditions can cause the board to insert the BDI maintenance signal back to the upstream site?

Show Suggested Answer Hide Answer
Suggested Answer: A, B, C

by Martin at Apr 28, 2024, 05:57 PM

Limited Time Offer

25%

Off

Get Premium H35-260 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Lanie
1 days ago
Wait, is the answer actually B) The board reports 0TU2_DEG? I thought that was about the TU2 signal degradation. This exam is tricky!
upvoted 0 times
...
Judy
2 days ago
I'm going with C) The board reports 0TU2_L0F. It just makes the most sense in the context of the question.
upvoted 0 times
...
Karl
3 days ago
Haha, the answer is definitely not A) The board reports R_LOS. That's just the receiver loss of signal, not the BDI maintenance signal!
upvoted 0 times
...
Chauncey
4 days ago
I'm not sure, but I think it might be D) 0DU2_PM_LCK. Isn't that when the performance monitoring lock is detected?
upvoted 0 times
...
Stephaine
11 days ago
I'm not sure, but I think it could also be D) 0DU2_PM_LCK because it could indicate a problem with the PM lock.
upvoted 0 times
...
Shonda
13 days ago
I agree with Elfriede, because R_LOS indicates loss of signal which would require the BDI maintenance signal.
upvoted 0 times
...
Larue
13 days ago
C) The board reports 0TU2_L0F seems like the correct answer. That's when the board detects a loss of frame on the TU2 interface.
upvoted 0 times
...
Elfriede
15 days ago
I think the answer is A) The board reports R_LOS.
upvoted 0 times
...
Alaine
16 days ago
I'm not sure, but I think it could also be D) 0DU2_PM_LCK because it could indicate a problem with the line clock.
upvoted 0 times
...
Arthur
21 days ago
I agree with Veronika, because R_LOS indicates loss of signal which would require inserting the BDI maintenance signal back.
upvoted 0 times
...
Veronika
23 days ago
I think the answer is A) The board reports R_LOS.
upvoted 0 times
...

Save Cancel