Genesys GE0-807 Exam - Topic 1 Question 106 Discussion

Actual exam question for Genesys's GE0-807 exam

Question #: 106
Topic #: 1

[All GE0-807 Questions]

When using the REFER method, where would you specify the party the call is being transferred to?

ARefer header URI

BTo: header

Ccontact: header

DREFER To: header

EIs not specified in the REFER messages

Show Suggested Answer

Suggested Answer: A

by Aliza at Jun 20, 2026, 09:30 PM

Limited Time Offer

25%

Off

Get Premium GE0-807 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Rose

1 month ago

I agree with A, but D is also a good choice. Clarity matters!

upvoted 0 times

...

Ramonita

1 month ago

I feel like it could be D) REFER To: header. More specific.

upvoted 0 times

...

Cathrine

2 months ago

I think it's A) Refer header URI. Seems logical.

upvoted 0 times

...

Von

2 months ago

Are you sure it's not E? That seems possible too.

upvoted 0 times

...

Arlette

2 months ago

Wait, I didn't know it was A!

upvoted 0 times

...

Oren

2 months ago

A is correct, but B is a common mistake.

upvoted 0 times

...

Lawrence

2 months ago

I thought it was B) To: header?

upvoted 0 times

...

Scarlet

2 months ago

It's definitely A) Refer header URI.

upvoted 0 times

...

Tiffiny

3 months ago

I'm confused about whether the contact: header is relevant here. I feel like I need to review the REFER method again.

upvoted 0 times

...

Freeman

3 months ago

This seems similar to a practice question we did where the REFER To: header was mentioned. Could that be the answer?

upvoted 0 times

...

Evan

3 months ago

I remember something about the To: header being important in SIP, but I can't recall if it applies here.

upvoted 0 times

...

Cristal

3 months ago

I think the party being transferred goes in the Refer header URI, but I'm not entirely sure.

upvoted 0 times

...