Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Fortinet Exam NSE7_LED-7.0 Topic 1 Question 1 Discussion

Actual exam question for Fortinet's NSE7_LED-7.0 exam
Question #: 1
Topic #: 1
[All NSE7_LED-7.0 Questions]

Refer to the exhibit

A device connected to port2 on FortiSwitch cannot access the network The port is assigned a security policy to enforce 802 1X authentication While troubleshooting the issue, the administrator obtains the debug output shown in the exhibit

Which two scenarios are likely to cause this issue? (Choose two.)

Show Suggested Answer Hide Answer
Suggested Answer: A, D

According to the exhibit, the debug output shows that the device connected to port2 on FortiSwitch is sending an EAPOL-Start message, which is the first step of the 802.1X authentication process. However, the output also shows that the device is not sending any EAP-Response messages, which are required to complete the authentication process. Therefore, option A is true because the device is not configured for 802.1X authentication, which means that it does not have the correct credentials or settings to authenticate with the RADIUS server. Option D is also true because the device does not support 802.1X authentication, which means that it does not have the capability or software to perform 802.1X authentication. Option B is false because the device has not been quarantined for 3600 seconds, but rather has a session timeout of 3600 seconds, which is the default value for 802.1X sessions. Option C is false because the device has not been assigned the guest VLAN, but rather has been assigned the default VLAN, which is VLAN 1.


Contribute your Thoughts:

Currently there are no comments in this discussion, be the first to comment!


Save Cancel