Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Fortinet Exam NSE7_EFW-7.2 Topic 5 Question 37 Discussion

Actual exam question for Fortinet's NSE7_EFW-7.2 exam
Question #: 37
Topic #: 5
[All NSE7_EFW-7.2 Questions]

Refer to the exhibit, which contains a partial BGP combination.

You want to configure a loopback as the OGP source.

Which two parameters must you set in the BGP configuration? (Choose two)

Show Suggested Answer Hide Answer
Suggested Answer: A, D

To configure a loopback as the BGP source, you need to set the ''ebgp-enforce-multihop'' and ''update-source'' parameters in the BGP configuration.The ''ebgp-enforce-multihop'' allows EBGP connections to neighbor routers that are not directly connected, while ''update-source'' specifies the IP address that should be used for the BGP session1.Reference:=BGP on loopback,Loopback interface,Technical Tip: Configuring EBGP Multihop Load-Balancing,Technical Tip: BGP routes are not installed in routing table with loopback as update source


by Aleshia at May 03, 2025, 08:51 PM

Limited Time Offer

25%

Off

Get Premium NSE7_EFW-7.2 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Graham
13 days ago
Haha, I bet the poor exam taker is scratching their head on this one. But D) update-source is the way to go!
upvoted 0 times
...
Alison
21 days ago
I believe the correct options are A) ebgp-enforce-multihop and D) update-source.
upvoted 0 times
...
Deangelo
21 days ago
Definitely D) update-source. I've seen this type of question before, and that's the key to configuring the BGP source interface.
upvoted 0 times
...
Jillian
26 days ago
I agree with Shanda, setting the update-source parameter makes sense.
upvoted 0 times
...
Danilo
1 months ago
Hmm, the correct answer has to be D) update-source. You need to specify the loopback interface as the source for BGP updates.
upvoted 0 times
Tegan
15 days ago
Got it, so the two parameters that must be set in the BGP configuration are D) update-source and A) ebgp-enforce-multihop.
upvoted 0 times
...
Carylon
19 days ago
Are you sure about that? I think it's A) ebgp-enforce-multihop.
upvoted 0 times
...
Chauncey
23 days ago
Yes, that's correct. Another parameter that needs to be set is A) ebgp-enforce-multihop.
upvoted 0 times
...
Lili
27 days ago
I agree, D) update-source is needed to specify the loopback interface as the source for BGP updates.
upvoted 0 times
...
...
Shanda
1 months ago
I think the answer is D) update-source.
upvoted 0 times
...

Save Cancel