MENU
-- Exhibit --
-- Exhibit --
Refer to the exhibit.
A layer 2 nPath routing configuration has been deployed. A packet capture contains a client connection packet with the following properties:
Source IP:
Destination IP:
At which two locations could the packet capture have been taken? (Choose two.)
Suggested Answer: C, A
Get Premium 301b Questions
as Interactive Web-Based Practice Test or PDF
Real Exam Format
Detailed Explanations
Instant Access
Get Your Practice Test
26 comments · newest first
AL
Alaine
3 months ago
Yes, both locations make sense. The packet must pass through them.
AL
Aleisha
4 months ago
I feel like it could also be at the client side.
CH
Cherri
4 months ago
Agreed. I think it could be taken at the virtual server.
ZA
Zana
4 months ago
This question is tricky.
JO
Johnna
5 months ago
Definitely not the server side, it’s all about the client and load balancer!
LE
Leonard
6 months ago
I thought nPath only works in specific setups, not sure about this.
MI
Mi
6 months ago
Wait, could it also be from the server side?
FL
Florinda
6 months ago
Totally agree, those are the likely spots!
PA
Pamella
6 months ago
This could be captured at the load balancer or the client side.
YU
Yuki
6 months ago
The load balancer and the virtual server seem like the most logical locations for the packet capture.
RA
Ranee
6 months ago
Haha, I bet the packet capture was taken in the server room with a magnifying glass and a lot of patience!
CA
Carma
7 months ago
Definitely the load balancer and the client A's network. That's where the packet would be visible.
SA
Sanjuana
7 months ago
I think the packet capture was taken at the load balancer and the virtual server.
LA
Lashawnda
7 months ago
The packet capture could have been taken at the load balancer or the client A's network.
ST
Staci
7 months ago
I think it has to be from the virtual server and the client A, but I might be mixing it up with another topic we covered.
GR
Graciela
7 months ago
I'm a bit confused about the nPath routing concept. I feel like the capture could be at either end, but I can't recall if there are restrictions on where it can be taken.
AN
Angella
8 months ago
I remember practicing a similar question where we had to identify packet capture points. It seems like the capture could also be at the load balancer, right?
TA
Tandra
8 months ago
I think the packet capture could be taken at the virtual server or the client A side, but I'm not entirely sure about the specifics of nPath routing.
RO
Rosalind
8 months ago
This seems straightforward. The packet capture was likely taken at the virtual server or at Client A's location, since those are the source and destination IPs mentioned.
DE
Denny
9 months ago
Based on the information provided, I think the packet capture could have been taken either at the virtual server or on the network between the virtual server and Client A. I'll double-check my understanding.
FL
Florinda
9 months ago
I'm a bit confused on the nPath routing concept. I'll need to review that before I can confidently answer this question.
GL
Glory
9 months ago
Okay, let's see. The source IP is the virtual server and the destination is Client A. I'm guessing the packet capture could have been taken at the virtual server or at Client A's location.
LU
Lucille
9 months ago
Hmm, this looks like a tricky one. I'll need to think through the layer 2 nPath routing configuration and where the packet capture could have been taken.
JE
Jesusa
3 months ago
Definitely needs some careful analysis of the routing paths.
GR
Gregg
3 months ago
What about the client side? That makes sense too.
CA
Carmela
3 months ago
I think it could be taken at the virtual server.