iPerf is an open source tool that is designed to perform a throughput test on the WLAN. iPerf is a cross-platform command-line tool that can measure the bandwidth and quality of network links by generating TCP or UDP traffic between two endpoints. iPerf can run as either a server or a client mode, depending on whether it receives or sends traffic. iPerf can also report various metrics of network performance, such as throughput, jitter, packet loss, delay, and TCP window size. To perform a throughput test on the WLAN using iPerf, one device needs to run iPerf in server mode and another device needs to run iPerf in client mode. The devices need to be connected to the same WLAN network and have their IP addresses configured properly. The device running iPerf in client mode needs to specify the IP address of the device running iPerf in server mode as well as other parameters such as protocol, port number, duration, interval, bandwidth limit, packet size, etc. The device running iPerf in server mode will listen for incoming connections from the client device and send back acknowledgments or responses depending on the protocol used. The device running iPerf in client mode will send traffic to the server device according to the specified parameters and measure the network performance. The device running iPerf in client mode will display the results of the throughput test at the end of the test or at regular intervals during the test.The results can show the average, minimum, maximum, and instantaneous throughput of the network link, as well as other metrics such as jitter, packet loss, delay, and TCP window size.Reference:1, Chapter 7, page 287;2, Section 4.3