Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Citrix 1Y0-241 Exam - Topic 8 Question 19 Discussion

Scenario: A Citrix ADC MPX is using one of four available 10G ports. A Citrix Administrator discovers a traffic bottleneck at the Citrix ADC.What can the administrator do to increase bandwidth on the Citrix ADC?
D) Add another 10G Citrix ADC port to the switch, and configure Link Aggregation Control Protocol (LACP).
A) Purchase another Citrix ADC MPX appliance.
B) Plug another 10G Citrix ADC port into the router.
C) Add two more 10G Citrix ADC ports to the network and configure VLAN.

Citrix 1Y0-241 Exam - Topic 8 Question 19 Discussion

Actual exam question for Citrix's 1Y0-241 exam
Question #: 19
Topic #: 8
[All 1Y0-241 Questions]

Scenario: A Citrix ADC MPX is using one of four available 10G ports. A Citrix Administrator discovers a traffic bottleneck at the Citrix ADC.

What can the administrator do to increase bandwidth on the Citrix ADC?

Show Suggested Answer Hide Answer
Suggested Answer: D

by Marguerita at May 04, 2022, 08:13 PM

Limited Time Offer

25%

Off

Get Premium 1Y0-241 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Annmarie
10 months ago
I disagree, LACP is the way to go for better bandwidth management.
upvoted 0 times
...
Floyd
10 months ago
Definitely need to consider purchasing another appliance if traffic keeps growing.
upvoted 0 times
...
Elza
11 months ago
Surprised that VLANs aren't mentioned more often for this!
upvoted 0 times
...
Gail
11 months ago
I think just plugging in another port won't solve the bottleneck.
upvoted 0 times
...
Kimbery
11 months ago
Adding another 10G port with LACP is a solid move!
upvoted 0 times
...
Marguerita
11 months ago
I'm pretty confident the answer is B and D - not enough time and low priority. Those are the biggest barriers to good documentation that I've seen in my experience.
upvoted 0 times
...
Kanisha
11 months ago
Wait, I'm confused. Shouldn't we rebuild the array to a higher redundancy level like RAID 6 before adding the new drive? Or is that overkill for a single drive failure? I'll have to double-check the best practices.
upvoted 0 times
...
Vincent
11 months ago
I'm a bit confused here. The question mentions that the Synchronization Service Manager doesn't display any sync jobs, so I'm not sure if option A is the right approach. Maybe I should consider the other options as well.
upvoted 0 times
...
Dannie
11 months ago
I remember studying network firewalls, and I think Firepower might be the right choice since it has advanced threat detection capabilities.
upvoted 0 times
...
Alecia
11 months ago
Hmm, I'm a bit unsure about this one. The question is asking about specific scenarios, so I'll need to think through each option and consider the differences between them.
upvoted 0 times
...

Save Cancel