Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Cisco 500-710 Exam - Topic 1 Question 43 Discussion

Which configuration on the Expressway is needed for a SIP end point to register?
D) SIPdomain
A) active neighbor zone between the end point and the Expressway
B) SIP authentication enabled
C) Registration restriction policy in Allow mode

Cisco 500-710 Exam - Topic 1 Question 43 Discussion

Actual exam question for Cisco's 500-710 exam
Question #: 43
Topic #: 1
[All 500-710 Questions]

Which configuration on the Expressway is needed for a SIP end point to register?

Show Suggested Answer Hide Answer
Suggested Answer: D

Contribute your Thoughts:

0/2000 characters
Clarinda
10 months ago
100% agree, neighbor zone is a must!
upvoted 0 times
...
Franklyn
10 months ago
Wait, does SIPdomain really matter that much?
upvoted 0 times
...
Anisha
11 months ago
Registration restriction policy in Allow mode is crucial too!
upvoted 0 times
...
Tran
11 months ago
I thought SIP authentication was the key?
upvoted 0 times
...
Allene
11 months ago
Definitely need an active neighbor zone for SIP registration.
upvoted 0 times
...
Yuriko
11 months ago
Okay, I'm pretty confident the answer is B. The Pre-Assessment Phase is where you define the scope, identify critical assets, and set up the planning and coordination for the assessment. The other options don't seem to fit as well.
upvoted 0 times
...
Jenifer
11 months ago
Hmm, I'm a bit unsure about this one. The requirement to make sure Product A is included when Product B is configured is a bit vague. I'll need to think through the different field options carefully.
upvoted 0 times
...
Lavonna
11 months ago
This looks like a straightforward stakeholder identification question. I'll go through the options carefully and select all the relevant stakeholders.
upvoted 0 times
...

Save Cancel