Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 500-220 Exam - Topic 8 Question 14 Discussion

Which order is accurate for a firmware upgrade on MX appliances in a high-availability configuration?
D) starts on the primary MX appliance and then occurs on the secondary MX appliance
A) starts on the secondary MX appliance and then occurs on the primary MX appliance
B) starts on both MX appliances at the same time and then reboots both appliances after traffic on the primary MX appliance ceases
C) starts on both MX appliances at the same time and then immediately reboots both appliances

Cisco 500-220 Exam - Topic 8 Question 14 Discussion

Actual exam question for Cisco's 500-220 exam
Question #: 14
Topic #: 8
[All 500-220 Questions]

Which order is accurate for a firmware upgrade on MX appliances in a high-availability configuration?

Show Suggested Answer Hide Answer
Suggested Answer: D

by Ozell at May 03, 2022, 07:36 PM

Limited Time Offer

25%

Off

Get Premium 500-220 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Cherry
10 months ago
C is a no-go, that would cause too much downtime!
upvoted 0 times
...
Tequila
10 months ago
Wait, is it really A? I always thought it was simultaneous.
upvoted 0 times
...
Telma
11 months ago
B sounds risky, rebooting both at once?
upvoted 0 times
...
Ammie
11 months ago
I thought it was D, but I guess A makes more sense.
upvoted 0 times
...
Elise
11 months ago
Definitely A, that's the standard procedure.
upvoted 0 times
...
Angelyn
11 months ago
I'm a little confused by the wording of this question. Is "replicating" the same as "backing up"? I'm not sure if A is the right answer or if there's another option that better fits the description. I'll have to read it over again carefully.
upvoted 0 times
...
Bette
11 months ago
Based on my understanding, changing the net address to be in the same area should do the trick. Option C looks like the way to go here.
upvoted 0 times
...
Evangelina
11 months ago
This looks like a pretty straightforward question on WRED. I think I have a good understanding of how it works, so I'll try to tackle this.
upvoted 0 times
...
Aleta
11 months ago
I remember we covered how it primarily helps route calls to agents in the ACCS, so I'd lean toward option A.
upvoted 0 times
...
Susana
11 months ago
I remember we talked about VPN configurations, but I'm not sure if the source and destination IPs are set correctly here.
upvoted 0 times
...

Save Cancel