Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Cisco 350-501 Exam - Topic 4 Question 29 Discussion

Refer to the exhibit.An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?A)B)C)D)
C) Option
A) Option
B) Option
D) Option

Cisco 350-501 Exam - Topic 4 Question 29 Discussion

Actual exam question for Cisco's 350-501 exam
Question #: 29
Topic #: 4
[All 350-501 Questions]

Refer to the exhibit.

An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?

A)

B)

C)

D)

Show Suggested Answer Hide Answer
Suggested Answer: C

Contribute your Thoughts:

0/2000 characters
Tyisha
10 months ago
Definitely need to check the config for D.
upvoted 0 times
...
Ammie
10 months ago
Wait, I didn't know LDP-IGP Sync was that important!
upvoted 0 times
...
Leila
11 months ago
Not sure about that, B seems more appropriate.
upvoted 0 times
...
Jose
11 months ago
I think Option C is the right choice!
upvoted 0 times
...
Peggie
11 months ago
LDP-IGP Sync is crucial for IS-IS adjacencies.
upvoted 0 times
...
Tyra
11 months ago
I'm a little confused by the wording of this question. I'll have to think it through step-by-step to figure out the best approach.
upvoted 0 times
...
Felix
11 months ago
I remember discussing how the Unified Communications Manager might not need that specific domain in its certificate. I think it's more about the Expressway servers.
upvoted 0 times
...
Noel
11 months ago
I think the key here is to focus on the "asynchronous" part of the pattern. The goal is to establish an environment where the service and consumer can communicate without being directly coupled. Options A and B seem to capture that idea best.
upvoted 0 times
...

Save Cancel