Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Cisco 350-401 Exam - Topic 13 Question 16 Discussion

Refer to the exhibit.Extended access-list 100 is configured on interface GigabitEthernet 0/0 in an inbound direction, but it does not have the expected behavior of allowing only packets to or from 192 168 0.0/16 Which command set properly configures the access list?
D) Option D
A) Option A
B) Option B
C) Option C

Cisco 350-401 Exam - Topic 13 Question 16 Discussion

Actual exam question for Cisco's 350-401 exam
Question #: 16
Topic #: 13
[All 350-401 Questions]

Refer to the exhibit.

Extended access-list 100 is configured on interface GigabitEthernet 0/0 in an inbound direction, but it does not have the expected behavior of allowing only packets to or from 192 168 0.0/16 Which command set properly configures the access list?

Show Suggested Answer Hide Answer
Suggested Answer: D

The first ACL statement of ''10 deny ip any any'' will match and drop all traffic so we have to remove this statement.


Contribute your Thoughts:

0/2000 characters
Annamae
9 months ago
I’m not convinced, I’d go with Option D instead.
upvoted 0 times
...
Albert
10 months ago
Totally agree with Veta on this one!
upvoted 0 times
...
Reid
10 months ago
Wait, isn't 192.168.0.0/16 too broad?
upvoted 0 times
...
Detra
10 months ago
I think Option B is the right choice.
upvoted 0 times
...
Veta
10 months ago
Option C allows the correct subnet.
upvoted 0 times
...
Coleen
10 months ago
I think I recall that the correct command should allow traffic from both directions, but I can't remember the exact syntax for the access list.
upvoted 0 times
...
Carry
11 months ago
I feel like I might be mixing up the inbound and outbound configurations. Did we cover how that affects access lists?
upvoted 0 times
...
Chara
11 months ago
This question seems similar to one we did in class about configuring extended access lists. I think it might be about the order of the rules.
upvoted 0 times
...
Reid
11 months ago
I remember we practiced access lists, but I'm not sure if the wildcard mask is correct for 192.168.0.0/16.
upvoted 0 times
...
Paz
11 months ago
I'm pretty confident that the high backend IOPs could be caused by a vSAN node failure. That would definitely increase the backend traffic as the system tries to rebuild the redundancy.
upvoted 0 times
...
Samira
11 months ago
This question seems straightforward, but I want to make sure I understand the responsibilities of the cloud computing service users correctly.
upvoted 0 times
...
Genevive
11 months ago
Ah, I remember learning about this in my networking class. The PING LOCALHOST command checks the loopback address to make sure the TCP/IP stack is set up correctly. I'm confident that's the right answer.
upvoted 0 times
...

Save Cancel