Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco Exam 300-710 Topic 2 Question 82 Discussion

Actual exam question for Cisco's 300-710 exam
Question #: 82
Topic #: 2
[All 300-710 Questions]

An engineer plans to reconfigure an existing Cisco FTD from transparent mode to routed mode. Which additional action must be taken to maintain communication Between me two network segments?

Show Suggested Answer Hide Answer
Suggested Answer: B

When reconfiguring an existing Cisco FTD from transparent mode to routed mode, an additional action that must be taken to maintain communication between the two network segments is to update the IP addressing so that each segment is a unique IP subnet. This is because in routed mode, the FTD device acts as a router hop in the network and requires each interface to be on a different subnet.In transparent mode, the FTD device acts as a layer 2 firewall and does not require different subnets for each interface1.

The other options are incorrect because:

Configuring a NAT rule so that traffic between the segments is exempt from NAT is not necessary to maintain communication between the two network segments. NAT is used to translate IP addresses between different networks, but it does not affect the routing of packets.Moreover, NAT is optional in routed mode and can be disabled if not needed2.

Deploying inbound ACLs on each interface to allow traffic between the segments is not required to maintain communication between the two network segments. ACLs are used to control access to network resources based on source and destination addresses, protocols, and ports. They do not affect the routing of packets.Furthermore, ACLs are optional in routed mode and can be configured as needed3.

Assigning a unique VLAN ID for the interface in each segment is not relevant to maintain communication between the two network segments. VLANs are used to create logical groups of hosts that share the same broadcast domain, regardless of their physical location or connection. They do not affect the routing of packets.Besides, VLANs are not supported in routed mode and can only be used in transparent mode4.


by Catarina at Mar 16, 2024, 03:18 AM

Limited Time Offer

25%

Off

Get Premium 300-710 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Tijuana
4 days ago
Agreed. I'm pretty sure that's the key - we need to make sure the IP addressing is set up correctly for the new routed mode configuration.
upvoted 0 times
...
Bulah
5 days ago
Haha, no kidding. Can you imagine? 'Oh, and by the way, you need to set up a unique VLAN ID for each interface.' That would just be pure evil.
upvoted 0 times
...
Felicidad
6 days ago
Hey, at least it's not asking us to configure a VLAN. That would just be cruel on a certification exam!
upvoted 0 times
...

Save Cancel