Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Cisco 300-510 Exam - Topic 7 Question 43 Discussion

Refer to the exhibit.A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired. Where should the soft preemption be applied to solve the issue?
B) under the tunnel-te1 interface on PE1
A) on the tail-end device for tunnel-te1 192.168.0.7
C) explicitly for tunnel-te 1 under the Cisco MPLS TE configuration mode after the timeout setting
D) Under the interface Loopback0 necessary for this deployment type.

Cisco 300-510 Exam - Topic 7 Question 43 Discussion

Actual exam question for Cisco's 300-510 exam
Question #: 43
Topic #: 7
[All 300-510 Questions]

Refer to the exhibit.

A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired. Where should the soft preemption be applied to solve the issue?

Show Suggested Answer Hide Answer
Suggested Answer: B

by Shenika at May 09, 2022, 03:20 PM

Limited Time Offer

25%

Off

Get Premium 300-510 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

0/2000 characters
Submit Cancel
Golda
10 months ago
Really? I thought Loopback0 was the go-to for this kind of setup.
upvoted 0 times
...
Sylvia
10 months ago
No way, it has to be explicitly set in the configuration mode!
upvoted 0 times
...
Veronique
11 months ago
Wait, isn't it supposed to be on the tail-end device?
upvoted 0 times
...
Marylou
11 months ago
I totally agree with that!
upvoted 0 times
...
Ty
11 months ago
Soft preemption should be applied under the tunnel-te1 interface on PE1.
upvoted 0 times
...
Joseph
11 months ago
This seems like a tricky question about data breach disclosure laws. I'll need to carefully read through the options and think about which one best matches the description.
upvoted 0 times
...
Willie
11 months ago
This seems pretty straightforward. I'll just plug the numbers into the formula and see which answer choice matches my calculation. As long as I don't make any silly mistakes, I should be able to get this right.
upvoted 0 times
...
Filiberto
11 months ago
I'm leaning towards option A as well. With well-defined functional requirements, we could use that as a starting point to build an operational profile and test the system's reliability under different usage scenarios.
upvoted 0 times
...
Candra
11 months ago
Okay, let's break this down. The question is asking about the conditions under which a government department can refuse to release information. I'll need to analyze each option and see which one aligns with the provisions of the RTI Act.
upvoted 0 times
...

Save Cancel