Reliable Cisco 350-801 Exam Dumps

Question No: 1

MultipleChoice

Which two protocols can be configured for the Cisco Unity Connection and Cisco UCM integration? (Choose two.)

Options

AH. 323

BSIP

CSCCP

DMGCP

ERTP

H323 is an older signaling protocol that is no longer widely used. MGCP, or Media Gateway Control Protocol, is a protocol used for controlling media gateways. RTP, or Real-time Transport Protocol, is a protocol used for transporting real-time data, such as voice and video

Question No: 2

MultipleChoice

An engineer is asked to implement on-net/off-net call classification in Cisco UCM. Which two components are required to implement this configuration? (Choose two.)

Options

ACTI route point

BSIP route patterns

Croute group

Droute pattern

ESIP trunk

Question No: 3

MultipleChoice

Which Cisco Unified communications manager configuration is required for SIP MWI integration?

Options

ASelect ''Redirecting Diversion Header Delivery--- Inbound' on the SIP trunk

BEnable ''Accept presence subscription'' on the SIP trunk security profile

CSelect ''Redirecting Diversion Header Delivery -- outbound'' on the SIP trunk

DEnable ''Accept unsolicited notification'' on the SIP Trunk security profile

Question No: 4

MultipleChoice

Why does Cisco UCM use DNS?

Options

Alt provides certificate-based security for media

Blt resolves FQDN to IP address resolution for trunks

Cit connects endpoints to single sign-on services.

Dlt provides SRV resolution to the endpoints registered

Question No: 5

MultipleChoice

To provide high-quality voice and take advantage of the full voice feature set, which two access layer switches provide support?

Options

AUse multiple egress queues to provide priority queuing of RTP voice packet streams and the ability to classify or reclassify traffic and establish a network trust boundary.

BUse 802, 1Q trunking and 802.1p for proper treatment of Layer 2 CoS packet marking on ports with phones connected.

CImplement IP RTP header compression on the serial Interface to reduce the bandwidth required per voice call on point-to-point links.

DDeploy RSVP to improve VoIP QoS only where it can have a positive impact on quality and functionality where there is limited bandwidth and frequent network congestion.

EMap audio and video streams of video calls (AF41 and AF42) to a class-based queue with weighted random early detection.

Question No: 6

MultipleChoice

An engineer roust configure DTMF relay on a Cisco Unified Border Element by using RFC2833 as the preferred relay mechanism and KPML as the

next preferred relay mechanism. The engineer logs in to the CUBE and enters the dial-peer configuration level. Which command should be run at

dial-peer configuration level?

Options

Adtmf-relay sip-kvmi rtp-nte

Bdtmf- relay rtp-nte sip-kpml

Cdtmf-relay sip-kgml rtp-inband

Ddtmf-relay rtp-inband sip-kvmi

Question No: 7

MultipleChoice

An engineer is configuring a BOT device for a Jabber user in Cisco Unified Communication Manager. Which phone type must be selected?

Options

ACisco Dual Mode for Android

BCisco Unified Client Services Framework

CCisco Dual Mode for iPhone

Dthird-party SIP device

Question No: 8

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. Which outgoing m-line SDP is sent to Cisco UCM after matching the appropriate dial peers via Cisco Unified Border Element?

A.

B.

C.

D.

Options

AOption A

BOption B

COption C

DOption D

Question No: 9

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. An engineer configures ISDN on a voice gateway. The provider confirms that the PRI is configured with 10 channels the engineer ordered and is working from the provider side, but the engineer cannot get a B-channel to carry voice. The rest of the configuration for the serial interface and voice network is functioning correctly. Which actions must be taken to carry voice?

Options

AThe engineer must activate the controller card on the voice gateway before configuring the device.

BThe engineer used a T1 interface but must use an E1 interface.

CThe pri-group timeslots command must be 0-9 for the 10 channels because all values on a router start with 0.

DThe engineer must manually revert the order of using the channels.

Question No: 10

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A collaboration engineer adds a redundant NTP server to an existing Cisco Collaboration solution On the Cisco UCM OS Administration page, the new NTP server shows as 'Not Accessible' Which action resolves this issue?

Options

ARestart NTPD on the Cisco UCM server.

BDelete and re-add the new NTP server via the Cisco UCM command-line interface

CStart the NTP service on the new NTP server

DConfigure the 'reach' value as '377' for the new NTP server.

Question No: 11

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. An administrator configured a codec preference list with 0,122 and ILBC codecs. Which change must the administrator make in the dial-peer section of the configuration to use this list?

Options

Aadd voice-codecs 20

Badd session codec 20

Cadd codec preference 20

Dadd voice-class codec 20

Question No: 12

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. The translation rule is configured on the voice gateway to translate DNIS. What is the outcome if the gateway receives 0255-343-1234 as DNIS?

Options

AThe translation rule is not matched because DNIS does not end with a '$'.

BThe translation rule is matched and the translated number is 02553431234.

CThe translation rule is matched and the translated number is 025553431234.

DThe translation rule is not matched because DNIS contains'-'.

Question No: 13

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. Given this 'debug isdn q921' output, what is the problem with the PRI?

Options

ANothing, the PRI is sending keepalives.

BLayer 2 is down on the controller.

CPRI does not have an IP address configured on the interface.

DLayer 1 is down on the controller.

Question No: 14

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. This INVITE is sent to an endpoint that only supports G.729. What must be done for this call to succeed?

Options

AAdd a transcoder that supports G.711ulaw and G.729.

BNothing; both sides support G.729.

CAdd a media termination point that supports G.711ulaw and G.729.

DNothing both sides support payload type 101.

Question No: 15

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. An engineer is troubleshooting this video conference issue:

*A video call between a Cisco 9971 in Region1 and another Cisco 9971 in Region1 works.

*As soon as the Cisco 9971 in Region1 conferences in a Cisco 8945 in Region2. the Regio1l endpoint cannot see the Region2 endpoint video.

What is the cause of this issue?

Options

AMaximum Audio Bit Rate must be increased.

BMaximum Session Bit Rate for Immersive Video Calls is too low.

CMaximum Session Bit Rate for Video Calls is too low.

DCisco 8945 does not have a camera connected.

Question No: 16

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. What is the registration state of the analog port in this debug output?

Options

AThe analog port failed to register to Cisco UCM with an error code 200.

BThe MGCP Gateway is not communicating with the Cisco UCM.

CThe analog port is currently shut down.

DThe analog port is registered to Cisco UCM.

Question No: 17

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. An administrator accesses the terminal of a Cisco UCM and starts a packet capture. Which two commands must the administrator use on Cisco UCM to generate DNS traffic? (Choose two.)

Options

Autils ntp status

Bshow cdp neighbor

Cshow version active

Dutils diagnose test

Eautils diagnose module validate Network

Question No: 18

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?

Options

AThe call fails because device mobility is turned on, and the phone is not configured in New York. The engineer must configure which sites the device should be roaming to.

BThe call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco.

CThe call fails because the Standard Local Route Group is being used only it no configuration is set for the device pools.

DThe call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway.

Question No: 19

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A collaboration engineer is configuring the Cisco UCM IM and Presence Service. Which two steps complete the configuration of the SIP trunk security profile? (Choose two.)

Options

ACheck the box to enable application-level authorization.

BCheck the box to allow charging header.

CCheck the box to accept unsolicited notification.

DCheck the box to transmit security status.

ECheck the box to accept replaces header.

Question No: 20

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. When making a call to a Mobile and Remote Access client, what are the combinations of protocol on each of the different sections A-B-C?

Options

AIP TCP/TLS (A) + SIP TCP/TLS (B) + SIP TLS (C)

BSIP TCP/TLS (A) + SIP TCP/TLS (B) + SIP TCP/TLS (C)

CSIP TLS (A) + SIP TLS (B) + SIP TLS (C)

DSIP TCP/TLS (A) + SIP TLS (B) + SIP TLS (C)

Free Cisco 350-801 Exam Dumps September 2026