Reliable Cisco 300-625 Exam Dumps

Question No: 1

MultipleChoice

A storage network engineer is implementing disk an ay data replication between two SAN environments in two different data centers not connected via Fibre Channel Which SAN switch feature must be implemented?

Options

AFCIP

Bzoning merge over LAN

CVSAN scoping

DIVR

Question No: 2

MultipleChoice

A storage network engineer must install and configure a new MDS switch in a data center network. Which two statements about available choices during the MDS switch initial setup are correct? (Choose two,)

Options

AThe engineer can choose what will be the administrator account

BThe secure password standard is required.

CThe engineer can configure the default zone policy.

DThe engineer can configure the default switch port trunK mode

EThe engineer does not have the choice to enable or disable full roneset distribution

Question No: 3

MultipleChoice

A storage administrator manually configure a storage switch to use a new static domain ID. After issuing an fcdomain restart vsan 1 command, the administrator sees that the switch is still using the existing domain ID. What is the reason why the configuration is not working?

Options

AStatic domain IDs apply only after a switch is rebooted.

BThe disruptive keyword was not used on the command.

CBuild fabric notifications were not sent to the other switches.

DDomain manager fast restart is not enabled on the switch.

Question No: 4

MultipleChoice

The principal switch on a Fibre Channel network fails to assign requested domain to a subordinate switch. What are two reasons? (Choose two )

Options

ACisco Fabric Services distribution is not enabled on the switch.

BThe fabric is locked.

CThe requested domain is outside the allowed list.

DThe persistent FC ID feature is not enabled.

EAn existing switch already has the requested domain assigned.

Question No: 5

MultipleChoice

A storage engineer is troubleshooting a Cisco MDS switch upgrade issue. What prevents the completion of a non-d.sruptive upgrade?

Options

AThe Fibre Channel host initiator is connected.

BThe Fibre Channel storage target is connected.

CThe Cisco Fabric Services operation in progress.

DThe Fibre Channel and FCoE storage targets are connected.

Question No: 6

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A network engineer created a new user that uses the VSAN-Admin role on a Cisco MDS switch so a new colleague can manage the VSANs configured on the switch. Which action is required for the configuration to give permission to the new colleague?

Options

Apermit vsan 1-1000 must be configured as rule 5

Bpermit vsan 1-1000 must be configured as rule 1

Cpermit vsan 1-1000 must be configured under the VSAN policy deny

Dpermit vsan 1-1000 must be configured under the VSAN policy allow

Question No: 7

DragDrop

Drag and drop the FLOGI parameters from the left onto the descriptions from which they were derived on the right.

Question No: 8

MultipleChoice

A storage network engineer is implementing a port channel for multiple FCIP interfaces with write acceleration in a clients storage network. Which channel mode must be used?

Options

Aon

Bpassive

Cactive

Dforce

Question No: 9

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A user who is logged in as an operator cannot update the zoneset. What is the cause of this issue?

Options

AThe fabric is locked by admin on switch-2

BHard zoning is enabled

CMerge control is disabled

DThe switch has a conflicting domain ID

EThe fabric is locked by admin on another switch

Question No: 10

MultipleChoice

Which feature on MDS platforms ensures that the code that is running on the hardware platform is authentic and unmodified, while also validating the BIOS to eliminate any rootkits?

Options

ACisco Secure Boot

BUEFI Secure Boot

CSecure Unique Device Identifier

DBIOS Secure Boot

Question No: 11

MultipleChoice

A network engineer must run a core Cisco Nexus 9500 Series Switch as a POAP server for all top-of-rack Cisco Nexus switches Which two network functions must run to provide the POAP service? (Choose two)

Options

ADNS

BPXE

CBOOTP

DTFTP

EDHCP

Question No: 12

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A network engineer must configure the SAN telemetry streaming feature to stream statistics from a Cisco MDS 9000 Series Switch to two external receivers with the IP addresses 192.168.1.4 and 192.168.1.5. Which two configurations accomplish this configuration? (Choose two)

Options

AAdd IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group 100.

BAdd IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group 300.

CAdd dst-grp 200 under subscription 100.

DAdd dst grp 300 under subscription 200.

EAdd dst-grp 100 under subscription 200.

Question No: 13

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. Device alias information must be merged for two fabrics. Which setting must match on both fabrics before the merge can be performed successfully?

Options

Adevice-alias mode

Bsession

Cqos

Dsmart-zoning

Question No: 14

MultipleChoice

Refer to the exhibit.

Refer to the exhibits A storage network engineer activates a zoneset on MDS-A and verifies the successful activation (Exhibit 1) The engineer is then notified that there is a SAN outage (Exhibit 2) What is the cause of the outage?

Options

AAnother network engineer activated zoneset ZoneSetMDS-B-VSAN100 on MDS-A.

BAnother network engineer issued the zone mode enhanced vsan 100 command on another switch in the fabric.

CAnother network engineer activated the zoneset ZoneSetMDS-B-VSAN100 command on another switch in the fabric.

DAnother network engineer issued the zone default-zone permit vsan 100 command on another switch in the fabric.

Question No: 15

MultipleChoice

Which two components are Required for successful MDS USB POAP? (Choose two)

Options

ANTFS formatted USB drive

BUSB drive in port 1

Cscript named poap_script.pl

DENTERPRISE_PKG license

Esystem and kickstart images

Question No: 16

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A port channel has been configured between a Cisco MDS and a Cisco Fabric Interconnect switch. Which interface(s) in the port channel carry the control plane traffic?

Options

Aper packet, balanced between interfaces fc1/9 and fc1/10

Bfrom interface fc1/9

Cfrom interface fc1/10

Dper flow, balanced between interfaces fc1/9 and fc1/10

Question No: 17

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A storage network engineer gets remote access to two Cisco MDS 9000 Series Switches with an ISL trunk and receives several log messages. Which set of actions resolve the problem while least affecting service?

Options

A1. Add 11:11:11:11:11:11:11:13 pwwn in zone Server11 and activate Zoneset10-A on MDS-A.
2. shut/no shut interface fc1/11 on MDS-A.

B1. Deactivate zone set Zoneset10-A on MDS-A.
2. shut/no shut interface fc1/11 on MDS-A.

C1. Add 11:11:11:11:11:11:11:13 pwwn in zone Server11 and activate Zoneset10-A on MDS A.
2. Remove VSAN 10 from the allowed VSAN range of interface fc1/11 on MDS-A and add it back in the range.

D1. Explicitly import zone set Zoneset10-A on MDS-B using the zoneset import interface fc1/11 vsan 10 command.
2. Activate the zone set Zoneset 10-A.

Question No: 18

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. An engineer is configuring Inter-VSAN routing for two Cisco MDS switches. The FSPF cost between the switches is 500, and the Cisco MDS core virtuahzes an IVR NAT domain as shown. Which statement about the topology is correct?

Options

AThe MDS-Core simulates an IVR NAT. and the FSPF cost is 500.

BThe MDS-Core simulates an IVR NAT and increases the cost to 501.

CThe MDS-Core simulates an IVR NAT and decreases the cost to 400.

DThe MDS-Core simulates an IVR NAT and increases the cost to 600.

Question No: 19

MultipleChoice

Refer to the exhibit

Refer to the exhibit. What is the result of merging the fabric?

Options

AThe merged fabric IVR VSAN topology is set to activate

BThe merged fabric has NAT enabled

CThe merge is invalid

DThe merged fabric contains only service group Group1

Question No: 20

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. Which configuration change improves the ability of the link to recover from frame loss?

Options

AIncrease the reset timeout.

BEnable selective acknowledgment.

CIncrease the send buffer size to 15000 KB.

DDisable PMTU discovery.

Free Cisco 300-625 Exam Dumps September 2026