Latest ASTQB CTFL Exam dumps 2026

Question No: 1

You are considering involving users during test execution. In general, what is the main reason for involving users during test execution? 1 credit

AThey are a cheap resource

BThey have good testing skills

CThis can serve as a way to build their confidence in the system

DThey have the ability to also focus on invalid test cases

Show Answer

Question No: 2

MultipleChoice

A top-down development strategy affects which level of testing most?

Options

AComponent testing

BIntegration testing

CSystem testing

DUser acceptance testing

Question No: 3

MultipleChoice

Which of the following is most likely to be a benefit of using static techniques?

Options

AFewer performance defects.

BProductivity improvements in the development process.

CMore efficient regression testing.

DQuick return on investment in static analysis tools.

Question No: 4

MultipleChoice

Acceptance test cases are based on what?

Options

ARequirements

BDesign

CCode

DDecision table

Question No: 5

MultipleChoice

During which test activity could faults be found most cost effectively?

Options

AExecution

BDesign

CPlanning

DCheck Exit criteria completion

Question No: 6

MultipleChoice

Which option best statements BEST describes one of the seven key principles of software testing?

Options

AAutomated tests are better than manual tests for avoiding the Exhaustive Testing.

BExhaustive testing is, with sufficient effort and tool support, feasible for all software.

CIt is normally impossible to test all input / output combinations for a software system.

DThe purpose of testing is to demonstrate the absence of defects. The purpose of testing is to demonstrate the absence of defects.

Question No: 7

MultipleChoice

In general, why is it NOT a good idea to estimate the testing effort based only on a percentage of development effort? Identify THREE valid reasons. 1 credit

Options

AThe quality of the development estimate may be poor.

BIn general bottom-up estimation is always better than top-down estimation.

CThe percentage based technique only applies to the V life cycle model.

DUsing the same percentage every time does not address the level of risk of the application to be tested.

EThe maturity of the organization, e.g. the quality of the test basis, quality of development testing, configuration management, availability of test tools, also influence the effort needed for testing.

FIt builds on large set of historical data

GThe result is almost always a too low estimate for the required test effort

Question No: 8

MultipleChoice

Risks should be constantly reviewed. Given the current situation, which one of the following factors is most likely to lead to a revised view of product risk? 3 credits

Options

AThe concerns over the user interface may lead to changes to the interface which cannot be implemented by development in time for the second test iteration.

BThe concerns over the user interface raises the likelihood of a risk in that area and increases the amount of test effort needed for the user interface, thereby limiting the test effort available for other parts of the test management tool.

CThe delivery of the application without the interface changes may upset the user community.

DThe method used for test estimation is not accurate enough and hence the money spent on testing exceeded its budget.

Question No: 9

MultipleChoice

What if the project isn't big enough to justify extensive testing..?

Options

AUse automation tool for testing

BUse risk based analysis to find out which areas need to be tested

CBoth a and b

DNone of the above

Question No: 10

MultipleChoice

IEEE 1028 also defines ''management review'' as a type of review. What is the main purpose of a management review? 1 credit

Options

AAlign technical concepts during the design phase

BEstablish a common understanding of requirements

CProvide independent evaluation of compliance to processes, regulations, standards etc.

DTo monitor progress, assess the status of a project, and make decisions about future actions

Question No: 11

MultipleChoice

''How much testing is enough?''

Options

AThis question is impossible to answer

BThis question is easy to answer

CThe answer depends on the risk for your industry, contract and special requirements

DThis answer depends on the maturity of your developers

Question No: 12

MultipleChoice

What do you mean by ''Having to say NO''..?

Options

ANo, the problem is not with testers

BNo, the software is not ready for production

CBoth a & b

DNone of the above

Question No: 13

MultipleChoice

What if the project isn't big enough to justify extensive testing..?

Options

AUse risk based analysis to find out which areas need to be tested

BUse automation tool for testing

CBoth a and b

DNone of the above

Free ASTQB CTFL Exam Dumps October 2026